Graco Inc 248083, 248082, 248084 manual Wetting Hose

Page 10

Wet inside of hose before each use to flush out sediment and prevent texture material from packing out hose.

1Pour one (1) gallon (3.8 liters) of clean water into hopper.

2 Close gun air valve (23).

3Start engine, page 15. Aim gun into hopper (G) and trigger gun to circulate water for a few min- utes to wet inside of material hose.

ti4290a

4Trigger gun into waste pail until hopper no longer contains water.

5Open gun air valve (23) to relieve compressor air.

Image 10

Contents 309915D ModelEquipment Misuse Hazard Fire and Explosion HazardCarbon Monoxide Hazard 309915DBurn Hazard Pressurized Equipment HazardComponent Identification Component Identification Pressure Relief Procedure Removing Hopper G Installing Hopper G SetupRemoving & Installing Hopper PreparationRemoving Compressor Power Pack Z Compressor Power PackRunning Compressor Remotely Reinstalling Compressor Power Pack Z Push compressor power pack Lift and turn motor lock knobWetting Hose Wetting System Use water-based materials Consistency Oughly mixed, gently set ballEnd of Material Thickness Slowly add one bag of texturePressure Relief Procedure Fuel Specifications Refueling ProcedureFueling Always have material outlet Plug installed in opening K orThat you are not using when There is material in hopper. IfStartup Starting Gas EngineSpray Techniques Application Nozzle Orifice Nozzle No Air VolumeNozzle Selection See Nozzle Selection, System AdjustmentAdjustment If flow adjustment nut will not Turn, check to see if it isCompressor Power Pack Performance English Shutdown and CleanupWhen you have finished spraying Relieve Pressure,Maintenance Technical Data Warranty Additional Warranty Coverage