Graco Inc 248084 manual Fire and Explosion Hazard, Carbon Monoxide Hazard, Equipment Misuse Hazard

Page 2

Warnings

The following Warnings are for the safe setup, use, grounding, maintenance and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. Refer back to these Warnings.

Warning

WARNING

This symbol alerts you to the possibility of seri- ous injury or death if you do not follow the instructions.

Caution

CAUTION

Alerts you to the possibility of damage or destruction of equipment if you do not follow the instructions.

Warnings

Fire and Explosion Hazard

Flammable fumes, such as solvent and paint fumes, in work area can ignite or explode. To help prevent fire and explosion:

Use equipment in well ventilated areas only.

Do not fill fuel tank while motor is running or hot; shut off motor and let it cool. Fuel is flammable and

can ignite or explode if spilled on hot surface.

• Eliminate all ignition sources; such as pilot lights, cigarettes, portable electrical lamps, and plastic drop cloths (potential static arc).

Keep work area free of debris, including solvent, rags, and gasoline.

Do not plug or unplug power cords or turn lights on or off when flammable fumes are present.

Carbon Monoxide Hazard

Exhaust contains poisonous carbon monoxide, which is colorless and odorless. Breathing carbon mon- oxide can cause death. Do not operate in an enclosed area.

Equipment Misuse Hazard

Equipment misuse can cause death or serious injury.

Do not exceed maximum working pressure or temperature rating of lowest rated system compo- nent. See Technical Data, in all equipment manuals.

Use fluids and solvents that are compatible with equipment wetted parts. See Technical Data in all equipment manuals. Read fluid and solvent manufacturer’s warnings.

Check equipment daily. Repair or replace worn or damaged parts immediately.

Do not alter or modify this equipment.

Use the equipment only for its intended purpose. Call your Graco distributor for information.

For professional use only.

Route hoses away from traffic areas, sharp edges, moving parts and hot surfaces.

Do not use hoses to pull equipment.‘

Comply with all applicable safety regulations.

2

309915D

Image 2
Contents 309915D ModelEquipment Misuse Hazard Fire and Explosion HazardCarbon Monoxide Hazard 309915DBurn Hazard Pressurized Equipment HazardComponent Identification Component Identification Pressure Relief Procedure Removing Hopper G Installing Hopper G SetupRemoving & Installing Hopper PreparationRunning Compressor Remotely Compressor Power PackRemoving Compressor Power Pack Z Reinstalling Compressor Power Pack Z Push compressor power pack Lift and turn motor lock knobWetting Hose Wetting System Use water-based materials Consistency Oughly mixed, gently set ballEnd of Material Thickness Slowly add one bag of textureFueling Fuel Specifications Refueling ProcedurePressure Relief Procedure Always have material outlet Plug installed in opening K orThat you are not using when There is material in hopper. IfStartup Starting Gas EngineNozzle Selection Application Nozzle Orifice Nozzle No Air VolumeSpray Techniques See Nozzle Selection, System AdjustmentAdjustment If flow adjustment nut will not Turn, check to see if it isCompressor Power Pack Performance English Shutdown and CleanupWhen you have finished spraying Relieve Pressure,Maintenance Technical Data Warranty Additional Warranty Coverage