Graco Inc 248082 manual Consistency Oughly mixed, gently set ball, End of Material Thickness, Only

Setup

Mixing Material

ti3906a

ti3907a

CAUTION

Do not use any solvent-based	NOTE: For best results, mix	2 Agitate to a smooth, lump-free	3 After texture material is thor-
materials.	material in a separate container	consistency.	oughly mixed, gently set ball
	and pour it into hopper.		end of Material Thickness
Use water-based materials	1 Slowly add one bag of texture		Gauge on surface of mixture.
only.
	to clean water as instructed on
Proper material mixture is	bag.
essential. The pump will not	For best results do not use partial
operate if material is too thick.
	bags.

READY ADD WATER

ti2498a

NOTE: For an accurate test, be sure gauge is completely dry and clean every time it is used.

4Observe ball on the material. When the material is thin enough to spray, the ball will sink completely into the mix- ture.

5If the ball does not sink com- pletely into the mixture within 10 seconds, add more water, agitate and try again.

NOTE: Thicker materials that do not pass the Material Thickness Gauge test, can be used. Before spraying thicker materials test pump performance first. If the material is too thick you will not achieve good results.

12 309915D