Graco Inc 248082, 248083, 248084 manual Startup, Starting Gas Engine

Page 15

Startup

Startup

Starting Gas Engine
B	TI3067A
TI3062A	C

D

TI3064A

E

OFF

ON

TI3065A

1 Move fuel valve (B) to open

2 Move choke (C) to closed

3 Set throttle (D) to fast

4 Set engine (E) switch ON

W
Start	R	D
		D
	ti3961a
Run	C
	C
	W
		Start
	ti3316a
	Run	TI3064A
ti3909a		TI3064A
ti3909a
	ti3909a

5Flip up pressure unloader valve (W) to START position.

6 Pull starter cord (R).

7After motor starts, move choke

(C) to open and pressure unloader (W) down, to RUN position.

8Set throttle (D) to desired set- ting.

309915D

15

Image 15

Contents Model 309915D309915D Fire and Explosion HazardCarbon Monoxide Hazard Equipment Misuse HazardPressurized Equipment Hazard Burn HazardComponent Identification Component Identification Pressure Relief Procedure Preparation SetupRemoving & Installing Hopper Removing Hopper G Installing Hopper GCompressor Power Pack Removing Compressor Power Pack ZRunning Compressor Remotely Push compressor power pack Lift and turn motor lock knob Reinstalling Compressor Power Pack ZWetting Hose Wetting System Slowly add one bag of texture Consistency Oughly mixed, gently set ballEnd of Material Thickness Use water-based materialsFuel Specifications Refueling Procedure Pressure Relief ProcedureFueling There is material in hopper. If Plug installed in opening K orThat you are not using when Always have material outletStarting Gas Engine StartupApplication Nozzle Orifice Nozzle No Air Volume Spray TechniquesNozzle Selection Turn, check to see if it is System AdjustmentAdjustment If flow adjustment nut will not See Nozzle Selection,Compressor Power Pack Performance Relieve Pressure, Shutdown and CleanupWhen you have finished spraying EnglishMaintenance Technical Data Additional Warranty Coverage Warranty