Graco Inc 248083, 248082, 248084 manual Setup, Preparation, Removing & Installing Hopper

Page 7

	Setup
	Setup
Preparation
	K
L
23	TI3056A
23
	cc
WLE	A
	ti3908a
N	dd
N
ti4003a

4Connect air and material hoses to gun. Tighten securely).

5Connect one end of material hose (cc) to material outlet (K or L) and the other end to gun material inlet (bb).

NOTE: Material plug must be installed in material outlet (K or L) you are not using.

6 Open gun air valve (23).

7Check engine oil level. Add SAE 10W-30 (summer) or

5W-20 (winter) oil, if neces- sary.

8Fill fuel tank (A) (Fueling, page 13).

Removing & Installing Hopper

		G
	ti3899a
	G
H		H
H
		ti3902a
	ti3900a	ti3925a
	Removing Hopper (G)	Installing Hopper (G)
The hopper (G) can be removed	1 Push down 2 latches on each	2 Position coupler (H) over material outlet and slide hopper (G)
from cart for cleaning and when	side of hopper coupler (H).	straight down, over the fitting as far as it will go, making sure hopper
using the Siphon Kit 248112,		bracket is positioned over cart handle rod.
available from your Graco	Lift hopper (G) straight up, off
distributor.	of unit.	Secure latches on each side by pushing them, firmly up, into locked
		position.

309915D

7

Image 7

Contents Model 309915D309915D Fire and Explosion HazardCarbon Monoxide Hazard Equipment Misuse HazardPressurized Equipment Hazard Burn HazardComponent Identification Component Identification Pressure Relief Procedure Preparation SetupRemoving & Installing Hopper Removing Hopper G Installing Hopper GRemoving Compressor Power Pack Z Compressor Power PackRunning Compressor Remotely Push compressor power pack Lift and turn motor lock knob Reinstalling Compressor Power Pack ZWetting Hose Wetting System Slowly add one bag of texture Consistency Oughly mixed, gently set ballEnd of Material Thickness Use water-based materialsPressure Relief Procedure Fuel Specifications Refueling ProcedureFueling There is material in hopper. If Plug installed in opening K orThat you are not using when Always have material outletStarting Gas Engine StartupSpray Techniques Application Nozzle Orifice Nozzle No Air VolumeNozzle Selection Turn, check to see if it is System AdjustmentAdjustment If flow adjustment nut will not See Nozzle Selection,Compressor Power Pack Performance Relieve Pressure, Shutdown and CleanupWhen you have finished spraying EnglishMaintenance Technical Data Additional Warranty Coverage Warranty