| Setup |
Wetting System |
|
ti3905a | TI |
| |
CAUTION | CAUTION |
1 Fill hopper (G) with prepared | Do not mix material in hopper. | 2 | Install tip. See Nozzle Selection | Do not allow material to flow out of |
texture material. | Mixing material in hopper can |
| Chart, page page 16. | gun when air valve (23) is closed or |
| damage hopper, result in an |
|
| material packout in needle can |
| inconsistent mix and packout can | 3 | Open gun air valve (23) to | occur. |
| occur. |
| relieve air pressure. |
|
TIA
T
U
ti3910a
NOTE: If spraying a simulated acoustic and coarse aggregate material, disconnect hose at gun, prime pump and hose and circulate material back into hopper for 10 seconds. Turn off pump. Install gun and tip.
4Inspect hose for kinks which could restrict fluid flow.
5Trigger gun into a pail. When texture material appears at tip, move gun to hopper and circu- late until there is a solid stream of texture material.
6See System Adjustment, page 17 for proper spray pattern and pump and gun adjustments.
7On the sprayer, adjust gun air pressure (U) and pump air pressure (T) to achieve desired results.
309915D | 11 |