Graco Inc 248082, 248083, 248084 manual Pressure Relief Procedure

Page 6

Pressure Relief Procedure

Pressure Relief Procedure

IMPORTANT

To reduce the risk of injury, follow this Pressure Relief Procedure whenever you:

•Are instructed to relieve pressure

•Stop spraying

•Service equipment

•Install or clean spray nozzle

•Disconnect or connect hose.

OFF

ON

E

TI3037A

23

TI

ti3903a

G

1Turn Engine ON/OFF (E) switch OFF.

2 Open gun air valve (23).

3 Trigger gun. Spray material back into hopper (G).

6

309915D

Image 6

Contents 309915D ModelEquipment Misuse Hazard Fire and Explosion HazardCarbon Monoxide Hazard 309915DBurn Hazard Pressurized Equipment HazardComponent Identification Component Identification Pressure Relief Procedure Removing Hopper G Installing Hopper G SetupRemoving & Installing Hopper PreparationCompressor Power Pack Removing Compressor Power Pack ZRunning Compressor Remotely Reinstalling Compressor Power Pack Z Push compressor power pack Lift and turn motor lock knobWetting Hose Wetting System Use water-based materials Consistency Oughly mixed, gently set ballEnd of Material Thickness Slowly add one bag of textureFuel Specifications Refueling Procedure Pressure Relief ProcedureFueling Always have material outlet Plug installed in opening K orThat you are not using when There is material in hopper. IfStartup Starting Gas EngineApplication Nozzle Orifice Nozzle No Air Volume Spray TechniquesNozzle Selection See Nozzle Selection, System AdjustmentAdjustment If flow adjustment nut will not Turn, check to see if it isCompressor Power Pack Performance English Shutdown and CleanupWhen you have finished spraying Relieve Pressure,Maintenance Technical Data Warranty Additional Warranty Coverage