Carrier 50HE003-006, 50HJ004 Evaporator-Fan Motor Efficiency, 003,004,005 006 74/84 007

50HE,HJ

Table 13—Accessory/FIOP Electric Heaters Static Pressure Drop (in. wg) — 50HJ004-007 and 50HE003-006

COMPONENT						CFM
	600	900	1200	1400	1600	1800	2000	2200	2400	2600
1 Heater Module	0.03	0.05	0.07	0.09	0.09	0.10	0.11	0.11	0.12	0.13
2 Heater Modules	0.14	0.15	0.16	0.16	0.16	0.17	0.17	0.17	0.18	0.18

Table 14—Accessory/FIOP EconoMi$er IV and EconoMi$er2 Static Pressure* (in. wg) — 50HJ004-007 and 50HE003-006

COMPONENT						CFM
	600	800	1000	1250	1500	1750	2000	2250	2500	2750	3000
Vertical EconoMi$er IV and EconoMi$er2	0.01	0.02	0.035	0.045	0.065	0.08	0.12	0.145	0.175	0.22	0.255
Horizontal EconoMi$er IV and EconoMi$er2	---	---	---	—	—	0.1	0.125	0.15	0.18	0.225	0.275

LEGEND

FIOP --- Factory ---Installed Option

*The static pressure must be added to external static pressure. The sum and the indoor entering-air cfm should be used in conjunction with the Fan Performance tables to determine indoor blower rpm and watts.

Table 14 — Evaporator-Fan Motor Efficiency

MOTOR 50HJ	EFFICIENCY
003,004,005	75
006	74/84*
007	84

*Single-phase/3-phase.

NOTE: Convert watts to bhp using the following formula:

bhp =	watts input x motor efficiency
	746	GENERAL FAN PERFORMANCE NOTES

1.Values include losses for filters, unit casing, and wet coils. See Table 13 and 14 and Fig. 46 for accessory/FIOP static pressure information.

2.Extensive motor and electrical testing on these units ensures that the full range of the motor can be utilized with confidence. Using the fan motors up to the ratings shown will not result in nuisance tripping or premature motor failure. Unit warranty will not be affected. See Table 11 and 12 on this page for additional information.

3.Use of a field-supplied motor may affect wire sizing. Contact your Carrier representative to verify.

4.Interpolation is permissible. Do not extrapolate.

5.Performance includes clean filter and wet coil.

Table 15—Fan Performance 50HE003 — Vertical Discharge Units; Standard Motor (Belt Drive)**

AIRFLOW				EXTERNAL STATIC PRESSURE (in. wg)
	0.1		0.2		0.4		0.6		0.8			1.0
(Cfm)
	Rpm	Bhp	Rpm	Bhp	Rpm	Bhp	Rpm	Bhp	Rpm	Bhp	Rpm		Bhp
600	500	0.08	531	0.08	607	0.14	713	0.21	788	0.29	878		0.37
700	529	0.09	567	0.09	633	0.16	739	0.24	816	0.32	902		0.41
800	547	0.1	592	0.12	660	0.19	761	0.27	845	0.37	937		0.47
900	570	0.13	620	0.14	691	0.22	793	0.32	870	0.42	957		0.53
1000	599	0.15	650	0.16	717	0.26	818	0.36	894	0.47	981		0.58

44