TROUBLE SHOOTING GUIDE
NOTE: REMOVE POWER SOURCE AND DRAIN TANK PRESSURE PRIOR TO MAKING ANY REPAIRS OR ADJUSTMENTS.
Problem | Probable Cause | Correction |
Unit will not run | Tank pressure exceeds “cut in” pressure | Once pressure drops below “cut in” pressure, the unit will start. |
| Extension cord causing excessive amp draw | Check guidelines for proper cord gauge |
|
| (use of extension cords is not recommended). |
| Fuse or circuit tripped | Replace fuse or reset breaker |
| Unit not turned on or not plugged in | Check pressure switch and verify that it is in the On position. |
|
| Verify that unit is plugged in. |
10 | Cold weather conditions | Place compressor in warmer environment for at least 30 minutes | ||
| ||||
| (typically temperatures below freezing) | then try restarting. | ||
Air leaks at fittings | Fittings loose | Tighten fitting. Check with soapy water. DO NOT OVER TIGHTEN. | ||
Unit will not build pressure | Application requires excessive air demand | Reduce demand on compressor | ||
| Loose head | Tighten bolts on head | ||
| Blown gasket | Remove head and check for | ||
|
| broken or deformed gasket. Replace if needed. | ||
| Open drain valve | Close drain valve | ||
Unit will not build pressure | Worn or broken valves | Remove head and replace valves. | ||
Air leak at tank or air tank | Damaged air tank |
|
|
|
welds. |
|
|
| DO NOT DRILL INTO , WELD OR OTHERWISE MODIFY AIR TANK. |
|
|
| ||
|
| DAMAGED OR MODIFIED TANKS CAN RUPTURE. REPLACE TANK IMMEDIATELY. |