Heath Zenith PF-4296-WI warranty Installation, Mode Switching Summary, DualBrite Dimmer Control

Mode Switching Summary

	TEST	ON-TIME Switch at 1,
			5, or 10 minutes
	AUTO		Flip light switch
			off for one second
MANUAL MODE
			then back on*

*If you get confused while switching modes, turn the power off for one minute, then back on. After the calibration time the control will be in the AUTO mode.

DualBrite® Dimmer Control

Light comes on half bright for selected time af- ter dusk (Off, 3 hr., 6 hr., until dawn).Selecting OFF disables this feature.The motion sensing features will continue to work as described in this manual. If motion is sensed, the light turns on full bright for the ON-TIME (1, 5, or 20 minutes) then returns to dim mode.

INSTALLATION

Estimated Installation Time: 30 minutes Items needed for installation (not included):

•	Phillips and flathead screwdrivers
•	Pliers	• Wire strippers/cutters
•	Safety glasses	• Light bulb
•	Silicone caulk

For best performance, mount the fixture about 6 feet (1.8 m) above the ground.

WARNING: Turn power off at circuit breaker or fuse.

1. Remove	2. Remove
two nuts.		X-Bar.

3. Tighten screws

finger tight.

SENSITIVITY

MINMAX

4.Set sensitivity on fixture back to the mid-position.

5. Attach X-Bar to

junction box

Junction

Box

Due to the size and weight of the fixture, you may find it helpful to have an assistant hold the fixture in place while connecting the wires.

598-1234-04