❒Walk through the coverage area noting where you are when the lights turn on. Move the sensor head left or right to change the coverage area.
IMPORTANT: Grasp the sensor only as shown and turn the entire sensor. Any other method may damage the sensor. Do not force the sensor past the stop- ping points.
|
| ° | 1 |
| 0 | 5 | |
| 5 |
| |
|
| ° | |
1 |
|
| 0 |
|
|
| |
Rotating Sensor Head to Change
Coverage Area
❒If you need to change the sensitivity, temporarily remove the fixture and make the adjustment. Too much sensitivity may increase false triggering.
❒Set the amount of TIME you want the light to stay on after motion is detected. (1, 5, or 10 minutes).
❒Set the amount of time after dusk you want the lights on accent level.
BULB REPLACEMENT
If lantern has an open bottom, insert bulb through opening and screw into socket.
If lantern has a closed bottom, follow the steps
below to replace bulb.
1. Model 4294 Only - Remove the lower
arm by removing
the two decorative screws attaching
the lower arm to
the canopy and lower glass as-
sembly.
2.Place one hand under lower glass assembly and un-
screw decorative screws holding lower glass as- sembly to top of fixture.
3.Replace bulb.
4.Reattach lower glass assembly to fix- ture top using decorative screws.
SPECIFICATIONS
Range | Up to 30 ft. (9.1 m) [var- |
| ies with surrounding |
| temperature]. |
Sensing Angle | Up to 150° |
Electrical Load | Up to 100 Watt Maximum |
| Tungsten Incandescent. |
Sensor Capacity.... | Up to 360 Watt (3.0 A.) |
| Maximum Tungsten In- |
| candescent. |
Power |
|
Requirements | 120 VAC, 60 Hz |
Operating Modes... | TEST, AUTO, and MAN- |
| UAL MODE |
Time Delay | 1, 5, 10 minutes |
DualBrite® Timer... | 3, 6 hrs, |