Elation Professional 575H manual Spot, Dfse, Reload the original factory settings

Page 36

Design Par 575H™

– This function allows the user to set a lamp “strike” delay time.

1.Access the main menu.

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DLAY” is displayed, press ENTER.

4.The display will show “D-XX.”

5.Press the UP and DOWN buttons to adjust the delay time.

6.When completed press ENTER to confirm.

7.Press MODE/ESC to return to the main menu.

SPOT

– This function allows you to optimize the lamp without the use of an external DMX controller. In this mode, the device will not react to any control signal.

1.Access the main menu.

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DFSE” is displayed, press ENTER.

4.The display will show “ON/OFF.”

5.Press the buttonUP to display “ON” toor activate“OFF” thisto deactivate this function.

6.Press ENTER to confirm.

7.Press MODE/ESC to return to the main menu.

DFSE

- With this function you can restore the factory default settings of the fixture. All settings will be set back to the default values. Any edited scenes will be lost. When restoring the factory settings the unit must be set to the address that the unit was in when you started editing. When you confirm this function, the fixture will begin to

reload the original factory settings.

1.Access the main menu.

2.Tap the UP button until “SPEC” is displayed, press ENTER.

3.Tap the UP button until “DFSE” is displayed, press ENTER.

4.The display will show “ON/OFF.”

©Elation Professional®

36

Design Par 575H™

Image 36
Contents Design Par 575H Contents General Information Never open this fixture while in use Design Par 575H Safety Instructions Design Par 575H Features General Guidelines Fixture Overview Design Par 575H Design Par 575H Lamp Installation Instructions Installing or replacing the lampLamp Optimization Design Par 575H Mounting and Installation MountingMounting points Clamp Mounting Securing the Design PAR 575H Understanding DMX DMX-512 control connection DMX-512 connection with DMX terminatorFixture DMX addressing Design Par 575H Display LED Indicators Default settings shaded Fixture MenuLamp OFF Setting/Changing the DMX Address Main Menu FunctionsAddress Menu Test MenuPlay Menu RUN AudiAuto Rese Reset Menu Lamp MenuALL ScanTime Menu LifeLamp ClmpRpan Menu Rtlt MenuFine Menu Degr Menu MIC MenuDisplay Menu Laau Automatic lamp start with power Fixture Settings LaauRdmx Controller Settings DlofDlay Reload the original factory settings SpotDfse Feed FansVER Adju Edit MenuREC StepSC01 RUN Design Par 575H DMX Channel Traits DMX channel function and values Error Codes Design Par 575H Cleaning and Maintenance Disconnect from mains before starting maintenance operationYear Limited Warranty Design Par 575H Photometric Data Dimensional Drawings Circuit Schematic Technical Specifications Power supply Power consumptionDesign Par 575H Elation Professional Design Par 575H Elation Professional Elation Professional