Elation Professional 575H manual Error Codes

Page 45

Design Par 575H™

12.ERROR CODES:

When power is applied, the unit will automatically enter a “reset/test” mode. This mode brings all the internal motors to a home position. If there is an internal problem with one or more of the motors an error code will flash in the display in the form of “XXer” were as XX will represent a function number. For example, when the display shows “03Er,” there is some type of error with the tilt motor. If there are multiple errors during the start-up process they will all flash in the display. For example: if the fixtures has errors on channel 1, and channel 2, at the same time, you will see the error message “01Er”, and “03Er,” flash repeated 5 times.

If an error does occur during the initial start-up procedure the fixture will self-generate a second reset signal and attempt to realign all the motors and correct the errors, if the error persist after a second attempt a third attempt will be made.

If after a third attempt all the errors have not been corrected the fixture will make the following determinations: 1) 3 or more errors - The fixture cannot function properly with three or more errors therefore the fixture will place itself in a stand-by mode until subsequent repairs can be made. 2) Less than 3 errors - The fixture has less than 3 errors, therefore most other functions will work properly. The fixture will attempt to operate normally until the errors can be correct by a technician. The errors in question will remain flashing in the display as a reminder of internal errors.

01Er – PAN movement error:

The yoke is not located in the default position after start-up or after a reset command. This message will appear after a fixture reset if the pan-yoke’s magnetic-indexing circuit malfunctions (sensor failed or magnet is missing) or there is a stepper motor failure (defective motor or a defective motor IC drive on the main PCB).

03Er – TILT movement error:

The head is not located in the default tilt position after start-up or after a reset command. This message will appear after a fixture reset if the tilt magnetic-indexing circuit

©Elation Professional®

45

Design Par 575H™

Image 45
Contents Design Par 575H Contents General Information Never open this fixture while in use Design Par 575H Safety Instructions Design Par 575H Features General Guidelines Fixture Overview Design Par 575H Design Par 575H Installing or replacing the lamp Lamp Installation InstructionsLamp Optimization Design Par 575H Mounting Mounting and InstallationMounting points Clamp Mounting Securing the Design PAR 575H Understanding DMX DMX-512 connection with DMX terminator DMX-512 control connectionFixture DMX addressing Design Par 575H Display LED Indicators Fixture Menu Default settings shadedLamp OFF Main Menu Functions Setting/Changing the DMX AddressAddress Menu Test MenuPlay Menu RUN AudiAuto Lamp Menu Rese Reset MenuALL ScanLife Time MenuLamp ClmpRpan Menu Rtlt MenuFine Menu Degr Menu MIC MenuDisplay Menu Laau Automatic lamp start with power Fixture Settings LaauRdmx Controller Settings DlofDlay Reload the original factory settings SpotDfse Feed FansVER Edit Menu AdjuStep RECSC01 RUN Design Par 575H DMX Channel Traits DMX channel function and values Error Codes Design Par 575H Disconnect from mains before starting maintenance operation Cleaning and MaintenanceYear Limited Warranty Design Par 575H Photometric Data Dimensional Drawings Circuit Schematic Power supply Power consumption Technical SpecificationsDesign Par 575H Elation Professional Design Par 575H Elation Professional Elation Professional