Elation Professional 575H manual Adju, Edit Menu

Page 38

Design Par 575H™

4.The display will show “V-1.0,” the display may also show, “V-2.0,” “V-9.9” etc.

5.Press ENTER or MODE/ESC to exit.

ADJU

- This function is used to calibrate the various internal motors in the event the internal homing mechanism become slightly out of adjustment. This function is protected with a password to prevent unauthorized personal from tampering with the fixture. To enter the calibration menu follow the steps below:

1.Access the main menu.

2.Tap the UP or DOWN buttons until “ADJU” is displayed, then press ENTER.

3.Tap the UP or DOWN buttons until “CODE” is displayed, then press ENTER.

4.The display will show “CXXX”, were as XXX represents the calibration password. The calibration password is “C050.” Use the UP or DOWN buttons to enter the proper password.

5.Once the proper password is entered the display will read “CHXX”, were as “XX” represents the fixture channel number, in the case of the Design Par 575H™ 1 ~ 16.

6.Select the desired channel to be calibrated by pressing the UP or DOWN buttons and then ENTER to confirm.

7.The display will then read “xxxx”, were “xxxx” stands for the calibrate values.

8.Adjust the desired calibration value between –128 and 127 by pressing the UP and DOWN. As you scroll up and down through the calibration values you will notice slight changes in the wheel or motor you are attempting to calibrate.

9.Once you reach your desired calibration press ENTER to confirm and lock in your calibration.

14.EDIT MENU

- This menu item allows you to write a program into the fixture’s internal memory (EEPROM) via the control panel or via an external DMX controller.

STEP (S-01 - S-48) - These are the steps slots that you write your programs into. There are at total of 48 steps.

©Elation Professional®

38

Design Par 575H™

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Design Par 575H Contents General Information Never open this fixture while in use Design Par 575H Safety Instructions Design Par 575H Features General Guidelines Fixture Overview Design Par 575H Design Par 575H Lamp Installation Instructions Installing or replacing the lampLamp Optimization Design Par 575H Mounting and Installation MountingMounting points Clamp Mounting Securing the Design PAR 575H Understanding DMX DMX-512 control connection DMX-512 connection with DMX terminatorFixture DMX addressing Design Par 575H Display LED Indicators Default settings shaded Fixture MenuLamp OFF Address Menu Setting/Changing the DMX AddressMain Menu Functions Test MenuAuto Play Menu RUNAudi ALL Rese Reset MenuLamp Menu ScanLamp Time MenuLife ClmpFine Menu Rpan MenuRtlt Menu Display Menu Degr MenuMIC Menu Laau Automatic lamp start with power Rdmx Fixture SettingsLaau Dlay Controller SettingsDlof Dfse Reload the original factory settingsSpot VER FeedFans Adju Edit MenuREC StepSC01 RUN Design Par 575H DMX Channel Traits DMX channel function and values Error Codes Design Par 575H Cleaning and Maintenance Disconnect from mains before starting maintenance operationYear Limited Warranty Design Par 575H Photometric Data Dimensional Drawings Circuit Schematic Technical Specifications Power supply Power consumptionDesign Par 575H Elation Professional Design Par 575H Elation Professional Elation Professional
Top Page Image Contents