Main Menu Functions, Address Menu | Elation Professional 575H

Design Par 575H™

Main Menu Functions

1. ADDRESS MENU

- AOO1 - A511 (Value) - This is where you set the fixtures DMX address.

Setting/Changing the DMX Address

After applying power to the DESIGN PAR 575H™ the LED will display the fixture’s current DMX address immediately after the reset sequence. If the fixture is not receiving a DMX signal the display will flash continuously. To set or adjust a DMX address, please follow the procedure below:

1.Switch on the DESIGN PAR 575H™ and wait for the fixture reset process to finished.

2.Press the Mode/Esc button to access the main menu. Toggle through the menu by pressing the Up and Down buttons until the display shows A001. Tap the enter button to make changes to the address, the current three digit address will immediately begin to flash.

3.While the current three-digit address is flashing, use the Up and Down buttons to select adjust the address. Lock your new address into the unit’s memory by pressing the Enter button. After the new address has been successfully stored into the fixture’s memory the LED will briefly readout PASS.

The DMX address is non-destructible and will remain in the fixture’s memory even when power to the fixture has been switched off. Memory is backed-up and retained by an internal power source with a five year shelf life.

2. TEST MENU

- T-01 - T-XX(Test) - Tests the functions of each channel. There are 16 DMX channels, and all except channels 7, 11, and 15 can be tested. To enter the test menu follow the procedure below:

1.Access the main menu.

2.Tap the UP button until “TEST” is displayed, press ENTER.

3.The display will show T-01. You can now press the up button and test the different channels. For example: If you press the up button until “T-03” is displayed, the unit

Design Par 575H™