Hitachi WR12DM2 Assembly and Operation, Applications, Removal and Installation Method of Battery

English

ASSEMBLY AND OPERATION

APPLICATIONS

<WH12DM2, WH9DM2>

Driving and removing of small screws, small bolts, etc. <WR12DM2, WR9DM2>

Tightening and loosening of all types of bolts and nuts, used for securing structural items.

REMOVAL AND INSTALLATION METHOD OF BATTERY

Handle
	Latch
Recharge-	Insert
able
battery	Pull out

(WH12DM2, WR12DM2)

How to install the battery

Align the battery with the groove in tool handle and slip it into place.

Always insert it all the way until it locks in place with a little click. If not, it may accidentally fall out of the tool, causing injury to you or someone around you. (Fig. 3)

How to remove the battery

Withdraw battery from the tool handle while pressing the latch on the side of the battery. (Fig. 3)

Fig. 3

CHARGING METHOD

NOTE: Before plugging into the receptacle, make sure the following points.

The power source voltage is stated on the nameplate.

The cord is not damaged.

WARNING: Do not charge at voltage higher than indicated on the nameplate.

If charged at voltage higher than indicated on the nameplate, the charger will burn up.

1.Insert the plug of battery charger into the receptacle.

When the plug of battery charger has been inserted into the receptacle, pilot lamp will blink in red. (At 1-second intervals)

WARNING: Do not use the electrical cord if damaged. Have it repaired immediately.

13