Hitachi WR12DM2, WR9DM2, WH12DM2, WH9DM2 instruction manual English

					English
	The light equipped hook has the following two functions:
		It can be used as a hook for suspending from a waist belt when required by the
		nature of the work.
		It can be used as an auxiliary light for such operations as tightening screws in a
		dark place.			5
1.1	Using the hook
					4
	The hook can be installed on the right or left side
				3	Hook
	and the angle can be adjusted in 5 steps between
	0° and 80°.
(1)	Operating the hook		2		(B)
	(a)	Pull out the hook toward you in the direction
					(A)
		of arrow (A) and turn in the direction of arrow
		(B). (Fig. 5)	1
	(b)	The angle can be adjusted in 5 steps (0°, 20°,
		40°, 60°, 80°).			Fig. 5
		Adjust the angle of the hook to the desired
		position for use.
(2)	Switching the hook position

CAUTION:

●If the tool falls, there is a risk that malfunction and/ or physical damage can occur. It is recommended that you also use fall-preventing wires, etc.

●Incomplete installation of the hook may result in bodily injury when used.

(a)Securely hold the main unit and remove the screw using a slotted head screwdriver or a coin. (Fig. 6)

(b)Remove the hook and spring. (Fig. 7)

(c)Install the hook and spring on the other side and securely fasten with screw. (Fig. 6)

NOTE: Pay attention to the spring orientation. Install the spring with larger diameter away from you. (Fig. 8)

1.2 Using as an auxiliary light

(1)Press the switch to turn off the light.

If forgotten, the light will turn off automatically after 15 minutes.

Loosen

Fig. 6

Spring

Fig. 7

Larger diameter faces away Fig. 8

17