Lincoln Electric IM718 manual Table A.4 Object Instance, Table A.3, Feed Head Board DIP Switch

A-10 INSTALLATION A-10

DIP Switch Settings and Locations

DIP switches on the P.C. Boards allow for custom configuration of the Power Wave. To access the DIP switches:

WARNING

•Turn off power at the disconnect switch.

------------------------------------------------------------------------

•Remove the top four screws securing the front access panel.

•Loosen, but do not completely remove, the bottom two screws holding the access panel.

•Open the access panel, allowing the weight of the panel to be carried by the bottom two screws. Make sure to prevent the weight of the access panel from hanging on the harness.

•Adjust the DIP switches as necessary.

•Replace the panel and screws, and restore power.

FEED HEAD BOARD DIP SWITCH:

			Switch		Description	Comments
	1				Object Instance LSB (see table A.3)
		2			Object Instance MSB (see table A.3)
3					Equipment Group 1 Select
4					Equipment Group 2 Select	Used for ArcLink Configuration
5					Equipment Group 3 Select
			6		Equipment Group 4 Select
				off	Electrode polarity positive (default)	Used for configuring electrode
						polarity (see Electrode and Work
7						Cable Connection in this Section)
				on	Electrode polarity negative
						No changes required for Power
						Wave AC/DC
				off	Low speed gear (default)	Used for configuring wirefeeder
8						gear ratio (see High Speed Gear
				on	High speed gear
						Box in this Section)

ETHERNET BOARD DIP SWITCH:

Bank S1

	Switch	Description		Comments
1		Object Instance LSB (see table A.3)
	2	Object Instance MSB (see table A.3)
3		Equipment Group 1 Select
4		Equipment Group 2	Select	Used for ArcLink Configuration
5		Equipment Group 3	Select
6		Equipment Group 4	Select
	7	Reserved for future use
8		Reserved for future use

Bank S2:

Switch Description Comments

1DeviceNet Baud Rate

2(See Table A.4)

3
4		Used for DeviceNet
5	DeviceNet Mac ID	Configuration

6(See Table A.5)

CONTROL BOARD DIP SWITCH

Switch Description Comments

1Object Instance LSB (see table A.3)

2Object Instance MSB (see table A.3)

3Equipment Group 1 Select

4	Equipment Group 2 Select	Used for ArcLink
5	Equipment Group 3 Select	configuration

6Equipment Group 4 Select

7Reserved for future use

	off	work sense lead not connected	Used for configuring
			work sense lead
8
	on	work sense lead connected	(See Work Volktage
			Sensing in Section A)

DeviceNet Baud Rate:

switch 1	switch 2	Baud rate
off	off	125K
on	off	250K
off	on	500K
on	on	Programmable value

TABLE A.4

OBJECT INSTANCE
switch 2	switch 1	Instance
off	off	0	(default)
off	on	1
on	off	2
on	on	3
	TABLE A.3

POWER WAVE AC/DC