Grizzly G1033X owner manual Tighten V-Belts, Recommended Adjustments

Tighten V-Belts

The final step in the set up process must be done after approximately 16 hours of operation. During this first 16 hours, the V-belts will stretch and seat into the pulley grooves. After this 16 hours, the V- belts must be tensioned or your belts will slip and burn out. Refer to Page 23 when you are ready to perform this important adjustment.

Note: Pulleys and belts run very hot. This is a normal condition. Allow them to cool before mak- ing adjustments.

Note: A collection of black belt dust at the bottom of the belt housing is a normal during the life of the machine.

-18-

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, some of these adjustments may need to be repeated to ensure optimum cutting results. Keep this in mind as you start to use your new planer.

Step-by-step instructions for these adjust- ments can be found in SECTION 7: SERVICE ADJUSTMENTS.

1.Table Parallelism (Page 28).

2.Chain Drive Tension (Page 28).

3.Infeed/Outfeed Roller Height (Page 30).

4.Spring Tension (Page 33).

5.Chip Breaker Height (Page 30).

6.Pressure Bar Height (Page 30).

7.Chip Deflector Positioning (Page 33).

Model G1033X (Mfg. since 4/10)