Handwheel |
|
Components and Hardware Needed: | Qty |
Handwheel | 1 |
Handwheel Bushing | 1 |
Handwheel Handle | 1 |
Hex Nut | 1 |
Flat Washer 12mm | 1 |
Key 4 x 4 x 10 | 1 |
To install the handwheel: |
|
1.Place the bushing on the handwheel shaft.
2.Insert the key into the shaft keyway.
3.Thread the handle into the handwheel.
4.Place the handwheel on the shaft and secure it with the
Figure 9. Installing handwheel on shaft.
Dust Hood |
|
Components and Hardware Needed: | Qty |
Dust Hood | 1 |
Flange Bolts | 6 |
DO NOT attach the dust hood if you do not intend to connect your planer to a dust col- lection system. Accumulated wood chips could cause a malfunction, resulting in per- sonal injury or damage to the planer.
To install the dust hood:
1.Attach the dust hood to the planer with six flange bolts as shown in Figure 10.
Figure 10. Dust hood attached.
2.If you have a dust collector, attach it to the dust hood now.
Note: To maximize work results and mini- mize clogging, chipout, etc., use a dust col-
lector with your planer! |
|
Model G1033X (Mfg. since 4/10)