Grizzly G1033X Moving & Placing Planer, Extension Wings, Components and Hardware Needed Qty

Moving & Placing

Planer

The Model G1033X is a heavy machine. Serious personal injury may occur if safe moving methods are not used. To be safe, get assistance and use power equipment to move the shipping crate and remove the machine from the crate.

The cabinet stand on the Model G1033X is equipped with lifting bars (see Page 5) to lift and place the planer.

When lifting the planer with a forklift, we recom- mend placing shop rags or cardboard between the forks and cabinet base so you do not scratch the paint.

Figure 6 shows an example of a typical planer with lifting bars being lifted correctly with a fork- lift.

Figure 6. Example of planer being lifted using

forklift.

Extension Wings

Components and Hardware Needed:	Qty
Table Extension Wings	2
Hex Bolts M8-1.25 x 25	6
Set Screws M8-1.25 x 20	6
To attach the table extension wings:

1.With the help of an assistant, attach the table extension wings to the planer table (Figure 7) with the M8-1.25 x 25 hex bolts. Hand tighten the bolts for now.

2.Install the M8-1.25 x 20 set screws (Figure 7) in the holes in the bottom of the wings.

Hex Bolts

Set Screws

Figure 7. Extension wing fasteners and leveling

controls.

3.Using a straightedge as a guide (Figure 8) and the set screws for leveling control, posi- tion the extension wings even with the table, then fully tighten the hex bolts.

Model G1033X (Mfg. since 4/10)

Figure 8. Leveling extension wings and table.

-15-