Bosch Power Tools RA1171 manual Assembling the Fence Figs

Router Table Assembly

ASSEMBLING THE FENCE

ASSEMBLING THE FENCE (Figs. 8 and 9)

1. Insert the pins molded into the top of the vacuum

port (18) into the holes on the rear of the aluminum

fence (16), as shown in Fig. 8.

2. From the underside of the fence, insert two

#10-32 x 5/8″ countersunk machine screws (37)

up through the holes in the bottom of the fence and

vacuum port. Secure in place with two #10-32 KEPS

nuts (29) (Fig. 8).

3. Place the fence right-side-up on a flat surface and

align the counterbored holes in the fence facings (17)

with the slotted holes in the fence. The counterbored

side of the facings should face OUT (Fig. 9).

4. Attach both fence facings (17) to the front of the fence,

using two 1/4-20 x 1″ carriage bolts (39) and two large

clamping knobs (19) for each fence facing (Fig. 9).

FIG. 8

16

18

29

37

5. From the front of the overhead guard (20), insert two

1/4-20 x 11⁄2″ carriage bolts (40) through the holes in the

guard. Slide a spacer (21) on each bolt so that the tabs

on the spacers fit into the slots on the guard.

6. From the front of the fence, insert the carriage bolts

through the holes in the top center of the fence. The

tabs on the spacers will fit into the top channel on the

fence. Secure in place with a small clamping knob (22)

on each bolt (Fig. 9).

NOTE: To simplify installation of the router adapter plate and router, do not install the fence onto the router table at this time.

NOTE: Two plastic jointing shims (23) are included to provide the proper fence offset when jointing. For more about jointing operations and shim placement, see page 27.

FIG. 9

2220

19 21

40

1739

13