Grizzly G0459P owner manual Test Run, Recommended Adjustments, To test run the machine

Test Run

Once the assembly is complete, test run your machine to make sure it runs properly.

If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review the Troubleshooting on Manual Page 23.

If you still cannot remedy a problem, contact our Tech Support at (570) 546-9663 for assistance.

To test run the machine:

1.Make sure you have read the safety instruc- tions at the beginning of the manual and that the machine is setup properly.

2.Make sure all tools and objects used during setup are cleared away from the machine.

3.Turn the machine ON, then rotate the vari- able speed knob clockwise to start the con- veyor belt.

4.Listen to and watch for abnormal noises or actions. The machine should run smoothly with little or no vibration or rubbing noises.

—Strange or unusual noises should be inves- tigated and corrected before operating the machine further. Always disconnect the machine from power when investigating or correcting potential problems.

5.Turn the machine OFF.

Model G0459/G0459P (Mfg. 7/11+)

Recommended

Adjustments

For your convenience, the adjustments listed below have been performed at the factory and no further setup is required to operate your machine.

However, because of the many variables involved with shipping, some of these adjustments may need to be repeated to ensure optimum results. Keep this in mind as you start to use your new drum sander.

Step-by-step instructions for these adjust- ments can be found in SECTION 7: SERVICE ADJUSTMENTS.

1.V-Belt Service (Page 30). Perform after the first 16 hours.

2.Conveyor Tensioning & Tracking (Page 32).

3.Drum Adjustments (Page 33).

4.Pressure Roller Height (Page 35).

-17-