Mounting
The base of this machine has holes that allow it to be mounted to a workbench. We strongly recommend that you mount your machine to a workbench to prevent it from moving during operation. An unexpected movement could result in an injury or property damage.
The strongest mounting option is a "Through Mount" where holes are drilled all the way through the workbench, and hex bolts, washers, and hex nuts are used to secure the drum sander to the workbench.
7dai |
;aViLVh]Zg |
7ORKBENCH |
;aViLVh]Zg |
AdX`LVh]Zg |
=ZmCji |
Figure 5. Example of a through mount setup.
Another option for mounting is a "Direct Mount" where the machine is simply secured to the work- bench with a lag screw.
AV\HXgZl
;aViLVh]Zg
7ORKBENCH
Figure 6. Example of a direct mount setup.
Model G0459/G0459P (Mfg. 7/11+)
Installing Crank
Handle
Components and Hardware Needed: | Qty |
Crank Handle | 1 |
The crank handle is installed on the front right lift screw shaft, and is held in place with two set screws already threaded into the handle.
To mount the handwheel, place the crank handle over the shaft shown in Figure 7 and, using a 3mm hex wrench, secure the handle with the two set screws.