Dust Collection
DO NOT operate the Model G0459/G0459P without an adequate dust collection system. This sander creates substantial amounts of wood dust while operating. Failure to use a dust collection system can result in short and
Recommended CFM at Dust Port: 150 CFM
Do not confuse this CFM recommendation with the rating of the dust collector. To determine the CFM at the dust port, you must consider these variables: (1) CFM rating of the dust collector,
(2)hose type and length between the dust col- lector and the machine, (3) number of branches or wyes, and (4) amount of other open lines throughout the system. Explaining how to cal- culate these variables is beyond the scope of this manual. Consult an expert or purchase a good dust collection
To connect a dust collection hose:
1.Remove the four Phillips head screws at the dust port hole.
2.Place the 21⁄2" dust port over the top cover mounting holes and secure with the screws removed in Step 1 (see Figure 8).
Figure 8. Dust port installation.
3.Fit a 21⁄2" dust hose over the dust port and secure in place with a hose clamp.
4.Tug the hose to make sure it does not come off. Note: A tight fit is necessary for proper performance.
Power Connection
6[iZg ndj ]VkZ XdbeaZiZY Vaa egZk^djh hZije ^chigjXi^dchVcYX^gXj^igZfj^gZbZcih!i]ZbVX]^cZ ^hgZVYnidWZXdccZXiZYidi]ZedlZghjeean#
Id Vkd^Y jcZmeZXiZY hiVgijeh dg egdeZgin YVb" V\Z!jhZi]Z[daadl^c\hiZehl]ZcZkZgXdccZXi^c\ dgY^hXdccZXi^c\i]ZbVX]^cZ#
Connecting Power
1. Ijgci]ZbVX]^cZedlZghl^iX]OFF#
2. >chZgi i]Z edlZg XdgY eaj\ ^cid V bViX]^c\ edlZg hjeean gZXZeiVXaZ# I]Z bVX]^cZ ^h cdlXdccZXiZYidi]ZedlZghdjgXZ#
Figure 9. Connecting power.
Disconnecting Power
1. Ijgci]ZbVX]^cZedlZghl^iX]OFF#
2. <gVhei]ZbdaYZYeaj\VcYejaa^iXdbeaZiZan djid[i]ZgZXZeiVXaZ#9dcdiejaaWni]ZXdgY Vhi]^hbVnYVbV\Zi]Zl^gZh^ch^YZ#