6.Remove the rear pressure roller (4 hex bolts and 4 flat washers) along with the brack- ets, compression springs, and spring plates shown in Figure 42.
Spring
Plate
Compression
Spring
NEW
BracketPHOTO
Figure 42. Rear pressure roller components.
7.Remove the rear panel.
8.Loosen the hex bolts securing the motor bracket to the frame, raise the motor and remove the V-belt from the motor pulley (see Page 31 for help). The drum sander should now look similar to Figure 43.
Figure 43. Drum sander disassembled
to Step 8.
Model G0459/G0459P (Mfg. 7/11+)
9.Remove the sanding drum (4 lock nuts and 4 flat washers) and
NEW
PHOTO
Figure 44. Location to remove sanding drum
components.
10.Remove the front roller end guard covers (4 Phillip head screws) and the rear roller end guard covers (4 Phillip head screws), and set the covers aside. The drum sander should now look similar to Figure 45.
Figure 45. Drum sander disassembled
to Step 10.