Hitachi CR 18DMR Important Safety Instructions for Battery Charger, Read ALL Instructions

Page 8

English

IMPORTANT SAFETY INSTRUCTIONS FOR BATTERY CHARGER

WARNING: Death or serious bodily injury could result from improper or unsafe use of battery chargers. To avoid these risks, follow these basic safety instructions:

READ ALL INSTRUCTIONS

1.This manual contains important safety and operating instructions for battery charger Model UC24YFA/UC24YJ/UC18YG.

2.Before using battery charger, read all instructions and cautionary markings on (1) battery charger, (2) battery, and (3) product using battery.

3.To reduce risk of injury, charge HITACHI rechargeable battery type EB7, EB9, EB12, EB14, EB18 series and EB24B. Other type of batteries may burst causing personal injury and damage.

4.Do not expose battery charger to rain or snow.

5.Use of an attachment not recommended or sold by the battery charger manufacturer may result in a risk of fire, electric shock, or injury to persons.

6.To reduce risk of damage to electric plug and cord, pull by plug when disconnecting battery charger.

7.Make sure cord is located so that it will not be stepped on, tripped over, or otherwise subjected to damage or stress.

8.An extension cord should not be used unless absolutely necessary. Use of improper extension cord could result in a risk of fire and electric shock.

If extension cord must be used make sure:

a.That blades of extension cord are the same number, size, and shape as those of plug on battery charger:

b.That extension cord is properly wired and in good electrical condition; and

c.That wire size is large enough for AC ampere rating of battery charger as specified in Table 1.

Table 1

RECOMMENDED MINIMUM AWG SIZE FOR

EXTENSION CORDS FOR BATTERY CHARGERS

AC Input Rating Amperes*

 

 

AWG Size of Cord

 

 

 

 

Equal to or

but less

 

Length of Cord, Feet (Meter)

 

greater than

than

25 (7.5)

50 (15)

100 (30)

150 (45)

0

2

18

18

18

16

2

3

18

18

16

14

3

4

18

18

16

14

*If the input rating of a battery charger is given in watts rather than in amperes, the corresponding ampere rating is to be determined by dividing the wattage rating by the voltage rating–for example:

1,250 watts

125 volts = 10 amperes

8

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Cordless Reciprocating Saw AvertissementContents Important Safety Information Meanings of Signal WordsSafety General Safety Rules for ALL Battery Operated Tools English Specific Safety Rules and Symbols Do not wipe plastic parts with solvent Important Safety Instructions for Battery Charger Read ALL InstructionsEnglish Make Them Available to Other Users Owners of this Tool Functional Description ModelName of Parts Cordless Reciprocating Saw CR18DMR〈UC18YG〉 Battery Charger 〈UC24YFA〉〈UC24YJ 〉 Specifications Battery ChargerAssembly and Operation Removal and Installation Method of BatteryApplications Charging Method〈UC24YFA〉 Regarding electric discharge in case of new batteries, etc Disconnect battery charger from the receptacleRemove the battery from the battery charger Insert the plug of battery charger into the receptacle Insert the battery to the battery chargerHow to make the batteries perform longer ChargingBattery overheated. Unable to charge Revitalizing the battery trickle recharge Center Mounting the blade Before USEPrior to Operation Dismounting the blade When the Blade is BrokenMaintenance and Inspection of SAW Blade Mount Confirm that the battery is mounted correctly HOW to USE the Cordless Reciprocating SAWAdjusting the base Switch operation Cutting metallic materialsPlunge cutting Cutting lumberSawing curved lines English Maintenance and Inspection Disposal of the exhausted battery Service and repairsService parts list Check for DustModifications Accessories Standard AccessoriesBattery EB1830HL Saw Blades Sold separatelyInformations Importantes DE Sécurité Signification DES Mots D’AVERTISSEMENTAvertissement Lire et coxmprendre toutes les instructions SecuriteConserver CES Instructions Avertissement Regles DE Securite Specifiques ET Symboles Manipuler l’outil motorisé avec précaution Ne pas essuyer les parties en plastique avec du solvantLire Tout CE Mode Demploi Français Français Description Fonctionnelle ModeleNOM DES Parties Scie alternative à batterie CR18DMRChargeur de batterie 〈UC24YFA〉 〈UC24YJ〉Chargeur de batterie Méthode DE Retrait ET D’INSTALLATION DE LA Batterie Méthode DE RechargeRecharge Brancher la fiche du chargeur de batterie dans la priseInsérer la batterie dans le chargeur de batterie Retirer la batterie du chargeur de batterie PrecautionDébrancher le chargeur de batterie de la prise Comment prolonger la durée de vie des batteries Français Revitalisation de la batterie recharge d’entretient Brancher la fiche du chargeur de batterie dans la prise Montage de la lame Avant L’UTILISATIONAvant L’OPERATON Démontage de la lame SI LA Lame EST Cassee Entretien ET Inspection DE LA Monture DE Lame’assurer que la batterie est montée Correctement.Socle Comment Utiliser LA Scie Alternative À BatterieRéglage du socle Fonctionnement de l’interrupteur Coupe de métauxCoupe de bois  Appuyer le socle fermement contre la pièceSciage de lignes courbes Attaque en plein boisEntretien ET Inspection Vérifier s’il y a de la poussière Mise au rebut d’une batterie uséeRangement Entretien et réparationListe des pièces de rechange Accessoires Accessoires StandardAccessoires SUR OPTION......vendus séparément Batterie EB1830HL LamesInformación Importante Sobre Seguridad Significado DE LAS Palabras DE SeñalizaciónAdvertencia Lea y entienda todas las instrucciones SeguridadGuarde Estas Instrucciones Advertencia Maneje correctamente la herramienta Normas Y Símbolos Específicos DE SeguridadUtilice la herramienta correcta Maneje con cuidado las herramientas eléctricas No limpie las partes de plástico con disolventeLEA Todas LAS Instrucciones Español Español Descripción Functional ModeloNomenclatura Sierra reciprocante a batería CR18DMRCargador de baterías 〈UC24YFA〉 〈UC18YG 〉Especificaciones Montaje Y Operación AplicacionesMétodo DE Extracción E Instalación DE LA Batería Método DE CargaInserte la batería en el cargador de baterías CargaDesconecte el cargador de baterías del tomacorriente Extraiga la batería del cargador de bateríasPrecaución Descarga eléctrica en caso de baterías nuevas, etcForma de hacer que las baterías duren más Minutos Rojo Finalizar Carga Desconecte el cargador de baterías del tomacorriente Revitalización de la batería recarga hábil Antes DE LA Utilización Desmontaje de la hoja Antes DE LA OperaciónMontaje de la hoja Cuando SE Rompa LA Hoja Como Usar LA Sierra Sable a Batería Cómo ajustar la baseCerciórese de que la batería esté correctamente instalada Carrera Presione la base firmemente contra la pieza de trabajo Operación del interruptorCorte de materiales metálicos Corte por penetración Corte de maderaCorte de líneas curvadas Español Mantenimiento E Inspección Comprobación del polvo Eliminación de las baterías agotadasAlmacenamiento Mantenimiento y reparaciónLista de repuestos ModificacionesAccesorios Accesorios EstándarAccesorios OPCIONALES......De venta por separado Batería EB1830HL HojasPage Page Blade Holder a Page Page Hitachi Koki Canada Co
Top Page Image Contents