Atari 040-0050-01 manual Connect the Computer

Page 20

Section 2 – Cabinet Conversion

Connect the Computer

Refer to Figure 7, Computer Rear Panel Diagram, on page 45, and Figure 5, Simplified Wiring Diagram, on page 44 to make the connections to the computer.

1.Connect the USB hub to one of the computer USB ports and install the game dongles in the USB hub. Refer to the section titled USB Game Dongles on page 37 for more information on the dongles and USB hub.

2.Connect the audio cable from the green audio port of the computer to J2 of the Jamma Conversion Board.

3.Connect the video cable from the computer VGA port to J1 of the UVC (if used) or the monitor.

4.Connect the USB cable from the computer USB port to the UGCI board.

Important: The USB connector from the UGCI board must be connected directly to the USB port on the computer, not to the USB hub.

5.Secure the wires to the cabinet so they do not get pinched or torn if the cabinet has a sliding control panel.

6.Connect the power cord from the computer to the AC power strip.

gvrSX™ Conversion System Manual

 

Page 20 of 48

040-0050-01 Rev. A 10/29/2004

Image 20
Contents GvrSX Conversion Instructions System Manual Table of Contents Table of FiguresPreface Safety FCC Notices United States GvrSX provides the following benefits to operators GvrSX design showcases the following featuresGame Description Cabinet Conversion Upgrade StepsClean and Prepare the Cabinet Remove old Tournament Header and Card Reader Conversion Kit Contents and Replacement Parts List Artwork Optional Monitor Upgrade Kit Components PGA-UPGRADE-MTRCDs, Labels, and Manuals Adapt the Cabinet for the Larger Monitor Replace the Monitor OptionalRemove the Old Monitor Page Install the New Monitor Install the Cabinet Exhaust Fan Drilling Cabinet Air HolesPage Set Up the Hardware Set Up AC Power DistributionRemove the Game PCB and Install New Hardware Connect the Jamma Conversion Board and UVC +5 VDC+12 VDC GroundInstall the Happ Ugci Board Happ Ugci Board ConnectionsSet Up the Computer Connect the Computer Secure the Computer Apply Control Panel Graphics Upgrade the Control PanelPrepare the Control Panel Install Buttons and Connect Wiring Apply the Cabinet Graphics and Marquee Artwork Apply the Serial Number Sticker Power on and Test the Cabinet Run the Joystick Calibration UtilityAdjust the Universal Video Converter UVC UVC DIP Switch SettingsUsing the Game Operator Menu Setting Game Options and ResetsMachine Menu Game Mode Menu Game Resets Menu All Audit Coin StatsAll Audit Game Stats All High Score StatsCoin Audits Game Purchase AuditGame Selection Player Control TestMonitor Calibration Test Starting a Game Playing a Beach Head Game Information Bar DescriptionUSB Game Dongles Game Software CDs Operating System Restore CDSystem Software CDs Troubleshooting Troubleshooting Video ProblemsTroubleshooting Audio Problems Problem Possible Cause Possible SolutionTroubleshooting Computer Problems Troubleshooting Control Problems Troubleshooting Miscellaneous ProblemsTroubleshooting Diagrams and Schematics Configuration with New Wells-Gardner MonitorDetailed Wiring Diagram Computer Rear Panel Diagram Computer Rear Panel DiagramWarranty Service Warranty InformationPage Technical Support