Atari 040-0050-01 manual Troubleshooting

Page 42

Section 7 – Troubleshooting

Problem

Possible Cause

Possible Solution

 

Faulty Fluorescent

Check the fluorescent tube for darkened or cracked

Marquee Lamp is

Tube

end. Replace the Fluorescent tube if it looks worn.

Faulty or

Faulty Fluorescent

Verify the fluorescent tube pins make a good

Intermittent

connection with the lamp fixture. Check the ballast for

 

Fixture

proper operation.

 

 

 

Incorrect Setting in

Check Credits per Game and Credits per Continue

Improper Number

Operator Menu

settings from Operator Menu.

of Credits given

 

Turn off the cabinet. Verify that all the wires are firmly

when Coins or Bills

Faulty Wiring

connected to each coin mech or Bill Validator. Verify

are Inserted

that no wires are frayed or improperly shorting to

 

 

ground.

 

Faulty Coin Mech

Verify the coin mech is not jammed. Make sure the coin

Game will not

mech is properly aligned and latched to the coin door.

 

accept Coins or

 

Verify the bill validator is powered on and working. If

Bills

Faulty Bill Validator

the bill validator is faulty, it will usually blink an error

 

 

code on the inside of the coin door.

gvrSX™ Conversion System Manual

 

Page 42 of 48

040-0050-01 Rev. A 10/29/2004

Image 42
Contents GvrSX Conversion Instructions System Manual Table of Contents Table of FiguresPreface Safety FCC Notices United States GvrSX design showcases the following features Game DescriptionGvrSX provides the following benefits to operators Upgrade Steps Clean and Prepare the CabinetCabinet Conversion Remove old Tournament Header and Card Reader Conversion Kit Contents and Replacement Parts List Optional Monitor Upgrade Kit Components PGA-UPGRADE-MTR CDs, Labels, and ManualsArtwork Replace the Monitor Optional Remove the Old MonitorAdapt the Cabinet for the Larger Monitor Page Install the New Monitor Install the Cabinet Exhaust Fan Drilling Cabinet Air HolesPage Set Up the Hardware Set Up AC Power DistributionRemove the Game PCB and Install New Hardware +12 VDC Connect the Jamma Conversion Board and UVC+5 VDC GroundInstall the Happ Ugci Board Happ Ugci Board ConnectionsSet Up the Computer Connect the Computer Secure the Computer Upgrade the Control Panel Prepare the Control PanelApply Control Panel Graphics Install Buttons and Connect Wiring Apply the Cabinet Graphics and Marquee Artwork Apply the Serial Number Sticker Power on and Test the Cabinet Run the Joystick Calibration UtilityAdjust the Universal Video Converter UVC UVC DIP Switch SettingsUsing the Game Operator Menu Setting Game Options and ResetsMachine Menu Game Mode Menu All Audit Game Stats Game Resets MenuAll Audit Coin Stats All High Score StatsCoin Audits Game Purchase AuditGame Selection Player Control TestMonitor Calibration Test Starting a Game Playing a Beach Head Game Information Bar DescriptionUSB Game Dongles Operating System Restore CD System Software CDsGame Software CDs Troubleshooting Audio Problems TroubleshootingTroubleshooting Video Problems Problem Possible Cause Possible SolutionTroubleshooting Computer Problems Troubleshooting Control Problems Troubleshooting Miscellaneous ProblemsTroubleshooting Diagrams and Schematics Configuration with New Wells-Gardner MonitorDetailed Wiring Diagram Computer Rear Panel Diagram Computer Rear Panel DiagramWarranty Service Warranty InformationPage Technical Support