Atari 040-0050-01 manual USB Game Dongles

Page 37

Section 5 – Starting a Game

USB Game Dongles

The three Beach Head games supplied with the cabinet use one USB game dongle. The dongle must be inserted in the USB port or the game will not work. When the USB Dongle is installed and working properly, a red LED will illuminate inside the dongle.

For a USB Game Dongle to be recognized correctly, it must be inserted into the USB port before the cabinet is powered ON. If the software does not recognize the USB Dongle, power the cabinet OFF and then ON to see if this resolves the problem.

If more game titles are made available for the gvrSX™ system in the future, each game will come with a USB Game Dongle. If more than one dongle is required, a USB hub can be used to provide extra USB Ports for multiple game dongles.

Important: If you use a USB hub, do not connect the USB cable from the HAPP UGCI Controller card to the USB hub. The card will not work properly if connected to the hub.

 

© 2004 GLOBAL VR®, INC.

040-0050-01 Rev. A 10/29/2004

Page 37 of 48

Image 37
Contents GvrSX Conversion Instructions System Manual Table of Figures Table of ContentsPreface Safety FCC Notices United States Game Description GvrSX design showcases the following featuresGvrSX provides the following benefits to operators Clean and Prepare the Cabinet Upgrade StepsCabinet Conversion Remove old Tournament Header and Card Reader Conversion Kit Contents and Replacement Parts List CDs, Labels, and Manuals Optional Monitor Upgrade Kit Components PGA-UPGRADE-MTRArtwork Remove the Old Monitor Replace the Monitor OptionalAdapt the Cabinet for the Larger Monitor Page Install the New Monitor Drilling Cabinet Air Holes Install the Cabinet Exhaust FanPage Set Up AC Power Distribution Set Up the HardwareRemove the Game PCB and Install New Hardware +5 VDC Connect the Jamma Conversion Board and UVC+12 VDC GroundHapp Ugci Board Connections Install the Happ Ugci BoardSet Up the Computer Connect the Computer Secure the Computer Prepare the Control Panel Upgrade the Control PanelApply Control Panel Graphics Install Buttons and Connect Wiring Apply the Cabinet Graphics and Marquee Artwork Apply the Serial Number Sticker Run the Joystick Calibration Utility Power on and Test the CabinetUVC DIP Switch Settings Adjust the Universal Video Converter UVCSetting Game Options and Resets Using the Game Operator MenuMachine Menu Game Mode Menu All Audit Coin Stats Game Resets MenuAll Audit Game Stats All High Score StatsGame Purchase Audit Coin AuditsPlayer Control Test Game SelectionMonitor Calibration Test Starting a Game Information Bar Description Playing a Beach Head GameUSB Game Dongles System Software CDs Operating System Restore CDGame Software CDs Troubleshooting Video Problems TroubleshootingTroubleshooting Audio Problems Problem Possible Cause Possible SolutionTroubleshooting Computer Problems Troubleshooting Miscellaneous Problems Troubleshooting Control ProblemsTroubleshooting Configuration with New Wells-Gardner Monitor Diagrams and SchematicsDetailed Wiring Diagram Computer Rear Panel Diagram Computer Rear Panel DiagramWarranty Information Warranty ServicePage Technical Support