Atari 040-0050-01 manual Remove old Tournament Header and Card Reader

Page 7

Section 2 – Cabinet Conversion

Remove old Tournament Header and Card Reader

If your cabinet has an existing tournament header or card reader, these components can be removed. They are not used by the gvrSX™ system.

The card reader is usually located near the coin door. The header is usually located at the top of the cabinet. Perform the following steps to remove the card reader and tournament header:

1.Unplug the data cables from the card reader and remove them from the cabinet.

2.Un-bolt the card reader and use the same carriage bolts to install a card reader blank plate (not provided).

3.Unplug the cables from the tournament header and remove them from the cabinet.

4.Un-bolt the tournament header and remove it from the cabinet.

 

© 2004 GLOBAL VR®, INC.

040-0050-01 Rev. A 10/29/2004

Page 7 of 48

Image 7
Contents GvrSX Conversion Instructions System Manual Table of Figures Table of ContentsPreface Safety FCC Notices United States Game Description GvrSX design showcases the following featuresGvrSX provides the following benefits to operators Clean and Prepare the Cabinet Upgrade StepsCabinet Conversion Remove old Tournament Header and Card Reader Conversion Kit Contents and Replacement Parts List CDs, Labels, and Manuals Optional Monitor Upgrade Kit Components PGA-UPGRADE-MTRArtwork Remove the Old Monitor Replace the Monitor OptionalAdapt the Cabinet for the Larger Monitor Page Install the New Monitor Drilling Cabinet Air Holes Install the Cabinet Exhaust FanPage Set Up AC Power Distribution Set Up the HardwareRemove the Game PCB and Install New Hardware Ground Connect the Jamma Conversion Board and UVC+5 VDC +12 VDCHapp Ugci Board Connections Install the Happ Ugci BoardSet Up the Computer Connect the Computer Secure the Computer Prepare the Control Panel Upgrade the Control PanelApply Control Panel Graphics Install Buttons and Connect Wiring Apply the Cabinet Graphics and Marquee Artwork Apply the Serial Number Sticker Run the Joystick Calibration Utility Power on and Test the CabinetUVC DIP Switch Settings Adjust the Universal Video Converter UVCSetting Game Options and Resets Using the Game Operator MenuMachine Menu Game Mode Menu All High Score Stats Game Resets MenuAll Audit Coin Stats All Audit Game StatsGame Purchase Audit Coin AuditsPlayer Control Test Game SelectionMonitor Calibration Test Starting a Game Information Bar Description Playing a Beach Head GameUSB Game Dongles System Software CDs Operating System Restore CDGame Software CDs Problem Possible Cause Possible Solution TroubleshootingTroubleshooting Video Problems Troubleshooting Audio ProblemsTroubleshooting Computer Problems Troubleshooting Miscellaneous Problems Troubleshooting Control ProblemsTroubleshooting Configuration with New Wells-Gardner Monitor Diagrams and SchematicsDetailed Wiring Diagram Computer Rear Panel Diagram Computer Rear Panel DiagramWarranty Information Warranty ServicePage Technical Support