Atari 040-0050-01 manual Install the New Monitor

Section 2 – Cabinet Conversion

Install the New Monitor

1.Refer to the picture below and make sure that the monitor frame of the new 27-inch Wells-Gardner®Monitor has the holes required to mount it to the cabinet brackets. Both the top and bottom sections of the frame must have two pairs of holes (some monitor frames have only one pair of holes in each section). The inside pair of holes must be centered on the bracket, and measure 19-1/4" center-to-center.

2.If the monitor frame does not have the required holes, drill them in both the top and bottom frame sections as follows: Drill two (2) 3/8" diameter holes, centered, 19-1/4" apart. Each of these new holes should be approximately 11/16" inboard from the existing holes, and on the same horizontal centerline.

Caution: Avoid getting drill chips in the electronic components.

CAUTION: The monitor is very heavy. Monitor installation requires at least two people. It is best to have a third person handling the monitor frame from inside the cabinet back door. It is easy to catch fingers between the monitor frame and cabinet.

3.To install the monitor, first install the lower edge of the monitor onto the lower bracket studs, and then rotate the monitor downwards to catch on the upper bracket studs. This will require at least two people. It may be best to have a third person handling the monitor frame from inside the back door. Watch your fingers; this monitor is very heavy.

gvrSX™ Conversion System Manual
Page 12 of 48	040-0050-01 Rev. A 10/29/2004