Omega CN1166 manual Controller SET-UP Mode

2CONTROLLER SET-UP MODE

In this mode, the parameters which define the operation of the controller are defined. Controller Set-Up Mode can be entered (whether or not there is a program currently running) as follows:

To display

Press

simultaneously

when display shows: to display:

changes every 2 seconds

Rolling display -

Press

then:

NOTE: Default (factory-set) lock code is 10.

Set upper display to

Controller Define lock code

NOTES:

Press

1.If the Controller Set-Up Mode lock code has been set to 0, pressing the Scroll key in Step 2 will give direct access to Controller Set-Up Mode; no entry of lock code is required.

2.If the upper display initially shows all decimal

points illuminated (see right), one or more configuration parameters have been altered and,

as a consequence, all Controller Set Up Mode parameters have been automatically set to their

default values/settings. To clear this display, simply alter the value/setting of any Controller Set Up Mode parameter.

Upon entry into Controller Set-Up Mode, the first in a sequence of controller parameters will be displayed. The operator may then step through the parameter sequence using the Scroll key, adjusting the setting/value of each displayed parameter using the Up/Down keys. The parameter sequence is as follows:

O077-2 Volume II 2-1