Omega CN1166 manual Volume O077-4

No. Parameter Notes

Segment Parameters - Program 3

1300	Run Program (value = Delayed Start value)	Write only
1301	No. of Cycles Programmed	1 to 9999 plus 10000 (INF)
1302	Timebase	0	= hours/mnutes, 1 = minutes/seconds
1303	Guaranteed Soak Band value	0	(OFF), 1 to span
1304	Final Setpoint values	Segment 1 at address 1304
to	(Soak = -32768, End = -16384)	￿
1319		Segment 16 at address 1319
1320	Rate values (Soak = -32768, End =	Segment 1 at address 1320
to	-16384)	￿
1335		Segment 16 at address 1335
1336	Time values	Segment 1 at address 1336
to		￿
1351		Segment 16 at address 1351
1352	Event Marker settings	Bit 0 = Event 16 ￿ Bit 15 = Event 1

Segment Parameters - Program 4

1400	Run Program (value = Delayed Start value)	Write only
1401	No. of Cycles Programmed	1 to 9999 plus 10000 (INF)
1402	Timebase	0 = hours/minutes, 1 =
		minutes/seconds
1403	Guaranteed Soak Band value	0 (OFF), 1 to span
1404	Final Setpoint values	Segment 1 at address 1404
to	(Soak = -32768, End = -16384)	￿
1419		Segment 16 at address 1419
1420	Rate values (Soak = -32768, End =	Segment 1 at address 1420
to	-16384)	￿
1435		Segment 16 at address 1435
1436	Time values	Segment 1 at address 1436
to		￿
1451		Segment 16 at address 1451

Some of the parameters which do not apply to a particular instrument configuration (e.g. PB2 on a single output instrument) will accept reads & writes. Others will accept reads only, and will return an exception if an attempt is made to write values to them. The values read will in all cases be undefined. It is the user’s responsibility to make sure that values read reflect a possible state of the instrument.

4-10 Volume II O077-4