Omega CN1166 manual Word Parameters, Controller Parameters

B.Word Parameters

No. Parameter Notes

Controller Parameters

1	Process Variable	Read only
2	Setpoint	Current setpoint, if ramping
3	Output Power	Read only, unless in Manual Control
4	Arithmetic Deviation	Read only
5	Proportional Band 2
6	Proportional Band 1
7	Controller Status
8	Reset
9	Rate
10	Output 1 Cycle Time
11	Scale Range Low	Read only if non-linear input
12	Scale Range High	Read only if non-linear input
13	Alarm 1 value
14	Alarm 2 value
15	Manual Reset
16	Overlap/Deadband
17	ON/OFF Differential
18	Decimal Point Position	Read only if non-linear input
19	Output 2 Cycle Time
20	Output 1 Power Limit
21	Setpoint Lock	0 = Off, 1 = On
22	Reserved
23	Filter Time Constant
24	Process Variable Offset
25	Recorder Output Max.
26	Recorder Output Min.
27	Alarm 1 Hysteresis
28	Alarm 2 Hysteresis

Program Parameters

29	Segment Mode	0 = Rate, 1 = Time
30	Profiler Status	Read only - see Subsection 4.5.
31	Current Program Number	Read only
32	Current Segment Number	Read only in current running/held program
33	Segment Time Remaining	Read only

4-8 Volume II O077-4