When a Test is Selected:
Symptom/Error Message
Explanation | How To Respond |
|
|
The QC Interval Controls Expired option is set to Warn or Lockout, and one or more control tests is past due.
(The menu item 2 – Continue appears only if this option is set to Warn). If the option is set to Lockout, each control test shown on the screen must be performed before the patient tests start.
Perform the control tests indicated in the message.
Press 1 to Exit.
or
If it appears, press 2 to continue patient testing.
The Upload Interval option is set to Warn or Lockout, and the specified interval has been exceeded.
(The menu item 2 – Continue appears only if this option is set to Warn). If the option is set to Lockout, data must be uploaded before testing starts.
The room temperature is outside the limits for testing.
| Data Review and |
| Review/Change Setup |
(119.3˚F) | functions are available. |
|
1.To upload data, do one of the following:
Place the monitor in the docking station (if the system has this option).
Plug the communications cable into the data port and connect to the laptop. (Refer to QC Manager Manual).
2.If the problem persists, notify the system administrator.
Press 1 to exit. or
If it appears, press 2 to continue testing.
Ensure that the room temperature is within the specified limits. Allow time for the monitor to stabilize to room temperature. Please refer to test strip instructions for use for appropriate operating temperature range. Press 1 to exit.
Questions? Refer to Page
