Installation and Configuration
2.Install the front standalone bracket cover:
a.Place the cover over the autoloader bracket.
b.Place the washers over the bracket holes and secure with a screw.
c.Repeat for the other side.
Figure 15: Installing the front standalone bracket covers
Clearance
Place the autoloader on a desk, table, or other stable, horizontal surface. Make sure the fan at the rear of the autoloader is not obstructed. Allow about 6 inches (about 15 cm) from wall or solid object at the rear. Allow about 12 inches (about 30 cm) to insert a cartridge in the mailslot, and about 28 inches (about 71 cm) to insert or remove a magazine at the front.
SSL1016 Tape Autoloader Reference Guide | 35 |