HP TippingPoint Next Generation Firewall manual Connector and Cable Pinout Specifications

A Connector and Cable Pinout Specifications

This information provides connector and pinout information for the NGFW Appliance and contains the following topics:

•”RJ-45 (COM) Console” on page 29

•”RJ-45 Ethernet Connectors” on page 29

•”Pluggable Transceivers” on page 30

RJ-45 (COM) Console

The following figure displays the RJ-45 connector and Table A-1shows the RJ-45 console connector pinouts.

Figure A-1 RJ-45 Connector

Table A-1 RJ-45 Console Connector Pinouts

Pin Number	Signal Name
1	Request to Send (RTS)
2	Data Terminal Ready (DTR)
3	Transmit Data (TxD)
4	Ground (GND)
5	Ground (GND)
6	Receive Data (RxD)
7	Data Set Ready (DSR)
8	Clear to Send (CTS)

RJ-45 Ethernet Connectors

Use the following pinout information when your RJ-45 device is operating in 10Mbps/100Mbps mode. Table A-2 RJ-45 Ethernet Connector Pinouts

Pin Number	Signal Name
1	Transmit positive (Tx+)
2	Transmit negative (Tx-)
3	Receive positive (Rx+)
4	Ground (GND)
5	Ground (GND)
6	Receive negative (Rx-)

Next Generation Firewall Hardware Specification and Installation Guide 29