HP 510x Print Server manual HP Jetdirect Product Information

Page 68

Table 7.1

HP Jetdirect Product Information

 

 

 

Message

 

Description

 

 

HP JETDIRECT JXXXXX

Identifies the HP Jetdirect print server model number.

 

 

FIRMWARE REVISION:

The firmware revision number of the HP Jetdirect print

X.XX.XX

 

server currently installed in the printer.

 

 

LAN HW ADDRESS:

The 12-digit hexadecimal network address of the

XXXXXXXXXXXX

HP Jetdirect print server.

 

 

 

PARALLEL

 

CENTRONICS indicates a standard parallel connection

PORT X:

 

that transfers data in one direction only (to the printer).

 

 

BIDIRECTIONAL indicates a parallel connection that

 

 

supports bidirectional communications.

 

 

BITRONICS indicates a parallel connection that supports

 

 

bidirectional communications.

 

 

ECP_MLC or ECP_MLC2 indicates a bidirectional parallel

 

 

connection (IEEE-1284) that supports an enhanced

 

 

capabilities port.

 

 

DISCONNECTED indicates that no printer is attached to

 

 

the port or the printer is not turned on.

 

 

 

MFG ID:

 

The manufacturing identification code.

 

 

DATE MANUFACTURED

Identifies the date of manufacture of the HP Jetdirect print

 

 

server.

 

 

PORT SELECT:

Specifies the port on the print server that has been

 

 

detected for use: RJ-45.

 

 

If DISCONNECTED is displayed, verify that the network

 

 

cable has been properly attached to the desired port.

 

 

PORT CONFIG

Indicates whether the RJ-45 port on the HP Jetdirect print

 

 

server is configured for network communications using a

 

 

10/100Base-TX full- or half-duplex channel.

 

 

AUTONEGOTIATION ON

Identifies whether IEEE 802.3 Autonegotiation on the

OFF

 

HP Jetdirect 10/100TX port is enabled (ON) or disabled

 

 

(OFF). If ON, the HP Jetdirect print server will attempt to

 

 

automatically configure itself onto the network at the

 

 

proper speed (10 or 100 Mbps) and mode (half or full

 

 

duplex). If OFF, you must manually configure the speed

 

 

and mode using switches or jumpers on the print server.

 

 

WEBJA SERVER

Identifies the IP address or domain name of the server that

xxx.xxx.xxx.xxx

the HP Jetdirect print server uses for Web Jetadmin

 

 

services.

 

 

 

68 HP Jetdirect Configuration Page Messages

ENWW

Image 68
Contents HP Jetdirect Print Server Page Administrator’s Guide HP Jetdirect Print Servers 300X/510X Trademark Credits Table of Contents Troubleshooting the HP Jetdirect Print Server HP Jetdirect Configuration Page MessagesUsing the Embedded Web Server TCP/IP OverviewIntroducing the HP Jetdirect Print Server Introduction Supported Print ServersSupported Networks Software, Driver, and Flash Image UpgradesSupport Materials HP Software Solutions Summary Software Solutions Table HP-UX Software SolutionsTCP/IP HP Jetdirect Printer Installer for UnixSystem Requirements HP Web JetadminInstalling HP Web Jetadmin Verifying Installation and Providing Access Configuring and Modifying a DeviceRemoving HP Web Jetadmin Software Internet Printer Connection Software Windows 2000/XP/ServerFeatures Windows Supported BrowsersSupported Proxies TCP/IP Configuration Introduction Linux and Unix systems For more information Using BOOTP/TFTP Why Use BOOTP/TFTPSystems That Use Network Information Service NIS Configuring the Bootp ServerBootp broadcast packets may not be Properly configuredNodename Bootptab File EntriesTags in the bootptab file 1 T144 Tftp Configuration File EntriesTags in the bootptab file 2 TCP/IP Configuration Tftp Configuration File Parameters 1 Ews-configTftp Configuration File Parameters 2 Using Dhcp Tftp Configuration File Parameters 3Unix Systems Windows SystemsWindows 2000 Server/Server TCP/IP Configuration Enabling or Disabling Dhcp Using Rarp Using the arp and ping Commands Unix Using Telnet TCP/IP Configuration Telnet Configuration Parameter Examples Telnet Configuration Parameter Examples 1 192.168.10.1Telnet Configuration Parameter Examples 2 Banner0Using the Embedded Web Server Using Telnet to Erase the Existing IP AddressMoving to Another Network Configuring for LPD Printing Introduction About LPDRequirements for Configuring LPD LPD Programs and Protocols Program Name Purpose of ProgramLPD Setup Overview Setting Up IP ParametersSetting Up Print Queues Supported Queue NamesPrinting a Test File Example Configuring Print Queues for BSD-based SystemsLPD on Unix Systems Example Configuring Print Queues Using SAM HP-UX systems For HP-UX systems, substitute lp -dfor lpr -P Installing TCP/IP Software LPD on Windows 2000/Server 2003 SystemsConfiguring for LPD Printing Select and enable Other Network File and Print Services Add LPR compatible printer windowVerifying the Configuration Printing from Windows ClientsFTP Printing Introduction RequirementsUsing FTP Printing Print FilesFTP Connections Control ConnectionFTP Login Ending the FTP SessionCtrl-C CommandsUser Commands for HP Jetdirect FTP Server Description Example of an FTP Session This is an example of a typical FTP printing sessionTroubleshooting the HP Jetdirect Print Server Introduction Resetting to Factory Defaults HP Jetdirect External Print ServersGeneral Troubleshooting Troubleshooting Chart Assessing the ProblemProcedure 1 Verifying that the Printer is On and Online Procedure 2 Printing an HP Jetdirect ConfigurationProcedure 3 Resolving Printer Display Error Messages Telnet IP address port Frames are using the same network Ethernet Configuration External Single Port Print Servers Troubleshooting the HP Jetdirect Print Server HP Jetdirect Configuration Page Messages Introduction Ethernet configuration pagesHP Jetdirect Product Information General HP Jetdirect Messages 1 General HP Jetdirect Messages 2 General HP Jetdirect Messages 3 General HP Jetdirect Messages 4 General HP Jetdirect Messages 5 General HP Jetdirect Messages 6 General HP Jetdirect Messages 7 General HP Jetdirect Messages 8 General HP Jetdirect Messages 9 General HP Jetdirect Messages 10 Network Statistics Novell NetWare Configuration Messages 1 IPX/SPX StatusMode Source RoutingNovell NetWare Configuration Messages 2 DLC/LLC Configuration MessagesTCP/IP Configuration Messages 1 TCP/IP Configuration Messages 2 Apple EtherTalk Configuration Messages 1Apple EtherTalk Configuration Messages 2 Snmp MessagesSnmp SET Cmty NameTransmission Control Protocol TCP TCP/IP Overview IntroductionInternet Protocol IP IP Address Network Portion IP AddressUser Datagram Protocol UDP IP Address Host Portion IP Address Structure and Class88 TCP/IP Overview Configuring IP Addresses Dynamic Host Configuration Protocol DhcpSubnets Subnet MaskDefault Gateway GatewaysUsing the Embedded Web Server Introduction Figure B.1 Embedded Web ServerBrowser Exceptions Supported HP Web Jetadmin VersionCompatible Web Browsers Viewing the Embedded Web Server Figure B.2 Entering the IP AddressSpecial Features Operating NotesConfiguration Error IndexIndex Network Frame Type Rcvd OUT of Buffers Overflow Error Tftp Progress Local Error Remote Error 76 Retries Exceeded Page Enww