HP 510x Print Server manual General HP Jetdirect Messages 8

Table 7.2	General HP Jetdirect Messages (8 of 10)
Message		Description
PSERVER CLOSED		The print server requested a termination of the connection
CONNECTION		with the HP Jetdirect print server. No error exists or is
		indicated. Make sure the print server is running, and
		restart it if necessary.
READY		The HP Jetdirect print server has successfully connected
		to the server and is awaiting data.
RECEIVE BUFFER		Run the power-on self-test: turn the print server off,
ERROR		then on again. If the error persists, replace the
		HP Jetdirect print server.
RETRY ERROR		Check the Ethernet cable. Make sure your HP Jetdirect
		print server is correctly attached to your network.
SQE ERROR		Run the power-on self-test: turn the print server off,
		then on again. If the error persists, replace the
		HP Jetdirect print server.
TFTP IN PROGRESS		The HP Jetdirect print server is currently in the process of
		obtaining its basic IP configuration information through
		TFTP and has not detected any errors.
TFTP LOCAL ERROR		The TFTP transfer of the configuration file from the host
		to the HP Jetdirect print server failed with the local print
		server encountering some form of inactivity timeout, or
		excessive retransmissions situation.
TFTP REMOTE ERROR		The TFTP transfer of the configuration file from the host
		to the HP Jetdirect print server failed with the remote host
		sending a TFTP ERROR packet to the print server.
TFTP RETRIES		The overall retrying of the TFTP transfer of the
EXCEEDED		configuration file from the host to the HP Jetdirect print
		server has exceeded a retry limit.
TRANSMIT ERROR		Check the network topology and verify all cable segments.
TRYING TO CONNECT		The HP Jetdirect print server is trying to connect to the
TO SERVER		print server or NetWare file server after being configured.
		Wait for the print server to establish a connection with the
		print or file server.
TURN PRINTER OFF/ON		This message may appear after you upgrade to a new
		version of firmware. When this message appears, turn the
		print server off, then back on to enable any new
		functionality that was recently downloaded.

76 HP Jetdirect Configuration Page Messages

ENWW