HP 510x Print Server manual General HP Jetdirect Messages 4

Table 7.2 General HP Jetdirect Messages (4 of 10)

Message	Description
LAN	Check the network connections. If the connections are
ERROR-CONTROLLER	intact, run the power-on self-test: turn the printer off, then
CHIP	on again. If the error persists, replace the HP Jetdirect
	print server.
LANERROR-EXTERNAL	The HP Jetdirect print server is incorrectly connected to
LOOPBACK	your network or is defective. Make sure your HP Jetdirect
	print server is correctly attached to your network. In
	addition, check the cabling and connectors.
LAN ERROR-INFINITE	There is a network congestion problem. Check network
DEFERRAL	cables.
	Note: If the print server is not connected to the network,
	this error cannot occur.
LAN ERROR-INTERNAL	Check all network connections.
LOOPBACK
LAN ERROR-LOSS OF	Check the network connections. If the connections are
CARRIER	intact, run the power-on self-test: turn the print server off,
	then on again. If the error persists, replace the
	HP Jetdirect print server.
LAN ERROR-NO	This message is displayed if Link Beat is not sensed.
LINKBEAT	Check the network cable, and verify that the
	concentrator/hub is providing Link Beat.
LAN ERROR-NO SQE	Check the network connections. If the connections are
	intact, run the power-on self-test: turn the print server off,
	then on again. If the error persists, replace the
	HP Jetdirect print server.
LAN ERROR-RECEIVER	There may be a problem with your network cabling or the
OFF	HP Jetdirect print server. Check the cabling and
	connectors on your Ethernet network. If you cannot find a
	problem with your network cabling, run the power-on
	self-test: turn the print server off, then on again. If the error
	persists after the printer is turned on again, there is a
	problem with the HP Jetdirect print server.
LAN ERROR-REMOVE	Run the power-on self-test: turn the print server off, then
RECEIVE	on again. If this message reappears on the resulting
	configuration page, you may have a problem with one of
	the HP Jetdirect print servers on your network. Check all
	the HP Jetdirect print servers on the network for proper
	operation.
LAN ERROR-RETRY	There is a problem with your network cabling or external
FAULTS	network configuration. Check the network cables and
	connections. Verify operation of the hub or switch port.

72 HP Jetdirect Configuration Page Messages

ENWW