HP 510x Print Server manual General HP Jetdirect Messages 1

Table 7.2 General HP Jetdirect Messages (1 of 10)

Message	Description
ARP DUPLICATE IP	The ARP layer has detected another node on the network
ADDRESS	using the same IP address as the HP Jetdirect print
	server. Extended error information below this message
	shows the hardware address of the other node.
BABBLE ERROR	Run the power-on self-test: turn the printer off, then on
	again. If the error persists, replace the HP Jetdirect print
	server. For information on replacing your HP Jetdirect
	print server, see the hardware installation guide for your
	print server.
BAD BOOTP REPLY	An error was detected in the BOOTP reply that the
	HP Jetdirect print server received. The BOOTP reply
	either had insufficient data in the UDP datagram to contain
	the minimum BOOTP header of 236 bytes, had an
	operation field that was not BOOTPREPLY(0X02), had a
	header field that did not match the print servers hardware
	address, or had a UDP source port that was not the
	BOOTP server port (67/udp).
BAD BOOTP TAG SIZE	The tagsize in a vendor specific field in the BOOTP reply
	is either 0, or greater than the remaining number of
	unprocessed bytes in the vendor specified area.
BOOTP/DHCP IN	The HP Jetdirect print server is currently in the process of
PROGRESS	obtaining its basic IP configuration information through
	BOOTP/DHCP, and has not detected any errors.
CF ERR - ACCESS LIST	The TFTP configuration file specified too many access list
EXCEEDED	entries using the “allow:” keyword.
CF ERR - FILE	The TFTP configuration file contained an incomplete last
INCOMPLETE	line that did not end in a newline character.
CF ERR - INVALID	A line in the TFTP configuration file contained an invalid
PARAM	value for one of the parameters on that line.
CF ERR - LINE TOO	A line being processed in the TFTP configuration file was
LONG	longer than the HP Jetdirect print server could accept.
CF ERR - MISSING	A line in the TFTP configuration file was missing a required
PARAM	parameter.
CF ERR - TRAP LIST	The TFTP configuration file specified too many trap
EXCEEDED	destination list entries using the “trap-destination:”
	keyword.
CF ERR - UNKNOWN	A TFTP configuration file line contained an unknown
KEYWORD	keyword.

ENWW HP Jetdirect Configuration Page Messages 69