HP 510x Print Server manual General HP Jetdirect Messages 2

Table 7.2	General HP Jetdirect Messages (2 of 10)
Message		Description
CONFIGURATION		The configuration information for the NetWare functions is
ERROR		not stored correctly on the HP Jetdirect print server. Rerun
		the installation software to reconfigure. If this error
		persists, there may be a problem with the HP Jetdirect
		print server.
CRC ERROR		Check the network topology and verify all cable segments.
		Check for damaged cables.
DHCP NACK		After several attempts, the DHCP server has failed to
		acknowledge the configuration. The Jetdirect print server
		will restart the configuration process.
DISCONNECTED		The Novell NetWare protocol is disconnected. Check the
		server and the print server.
DISCONNECTING		The server has been shut down because of a configuration
FROM SERVER		change or reset request. This message automatically
		clears after a few seconds, unless the printer is offline, is
		in an error state, or is servicing another I/O port or another
		network protocol.
DISCONNECTING - SPX		The SPX connection to the print server was lost after the
TIMEOUT		connection had been made. This indicates a possible
		network problem, or a problem with the print server. Make
		sure all cables and routers are functioning correctly. Try
		restarting the print server.
DUP NODE ADDRESS		The HP Jetdirect print server found another station on the
		ring that already has the address which the HP Jetdirect
		print server wishes to use. Make sure that all addresses
		are unique.
ERR NEGOTIATING		A failure was detected when selecting the buffer size to be
BUFFER SIZE		used when reading print data from the file server. This may
		indicate a network problem.
		When the HP Jetdirect print server is configured for
		multiple file servers, the error is only displayed on the
		configuration page if none of the file servers was
		successfully connected.
FAIL RESERVING		The SPX connection to the print server was lost when the
PRINTER NUM		HP Jetdirect print server attempted to reserve the printer
		number. This indicates a possible network problem, or a
		problem with the print server. Make sure all cables and
		routers are functioning correctly. Try restarting the print
		server.
FRAMING ERROR		Check the network topology and verify all cable segments.
		Check for damaged cables.

70 HP Jetdirect Configuration Page Messages

ENWW