HP 510x Print Server manual General HP Jetdirect Messages 3

Page 71

Table 7.2 General HP Jetdirect Messages (3 of 10)

Message

Description

 

 

INITIALIZING TRYING

The HP Jetdirect print server is trying to connect to the

TO CONNECT TO

NetWare server(s). This is a normal message. Wait until

SERVER

the connection is established or another status message

 

appears.

 

 

INVALID GATEWAY

The default gateway IP address specified for the

ADDRESS

HP Jetdirect print server (through BOOTP or NOVRAM)

 

is an invalid IP address for specifying a single node.

 

 

INVALID IP ADDRESS

The IP address specified for the HP Jetdirect print server

 

(through BOOTP or NOVRAM) is an invalid IP address for

 

specifying a single node.

 

 

INVALID SERVER

The TFTP server IP address specified for the HP Jetdirect

ADDRESS

print server (through BOOTP) is an invalid IP address for

 

specifying a single node.

 

 

INVALID SUBNET MASK

The IP subnet mask specified for the HP Jetdirect print

 

server (through BOOTP or NOVRAM) is an invalid subnet

 

mask.

 

 

INVALID SYSLOG

The syslog server IP address specified for the

ADDRESS

HP Jetdirect print server (through BOOTP) is an invalid IP

 

address for specifying a single node.

 

 

INVALID TRAP DEST

One of the SNMP trap (Trap PDU) destination IP

ADDRESS

addresses specified for the HP Jetdirect print server

 

(through TFTP) is an invalid IP address for specifying a

 

single node.

 

 

I/O CARD INITIALIZING

The HP Jetdirect print server is initializing the network

(INIT)

protocols. For more information, see the network

 

operating system status line on the configuration page.

 

 

I/O CARD NOT READY

There is a problem with the print server or its configuration.

 

Following the I/O CARD NOT READY message is a status

 

message. See this table for a detailed explanation of all

 

status messages.

 

 

I/O CARD READY

The HP Jetdirect print server is connected and awaiting

 

data.

 

 

LAN ERROR-AUTO

Run the power-on self-test: turn the printer off, then on

REMOVAL

again. If this message reappears on another configuration

 

page, you may have a problem with one of the HP Jetdirect

 

print servers on your network. Check all the print servers

 

on the network for proper operation.

 

 

LAN ERROR-BABBLE

Check the network connections. If the connections are

 

intact, run the power-on self-test: turn the printer off, then

 

on again. If the error persists, replace the HP Jetdirect

 

print server. For replacement instructions, see the

 

hardware installation guide for your print server.

 

 

ENWW

HP Jetdirect Configuration Page Messages 71

Image 71
Contents HP Jetdirect Print Server Page Administrator’s Guide HP Jetdirect Print Servers 300X/510X Trademark Credits Table of Contents TCP/IP Overview Troubleshooting the HP Jetdirect Print ServerHP Jetdirect Configuration Page Messages Using the Embedded Web ServerSupported Print Servers Introducing the HP Jetdirect Print Server IntroductionSupported Networks Software, Driver, and Flash Image UpgradesSupport Materials HP Software Solutions Summary Software Solutions Table HP-UX Software SolutionsTCP/IP Unix HP Jetdirect Printer Installer forSystem Requirements HP Web JetadminInstalling HP Web Jetadmin Verifying Installation and Providing Access Configuring and Modifying a DeviceRemoving HP Web Jetadmin Software Windows 2000/XP/Server Internet Printer Connection SoftwareFeatures Windows Supported BrowsersSupported Proxies TCP/IP Configuration Introduction Linux and Unix systems For more information Why Use BOOTP/TFTP Using BOOTP/TFTPProperly configured Systems That Use Network Information Service NISConfiguring the Bootp Server Bootp broadcast packets may not beNodename Bootptab File EntriesTags in the bootptab file 1 T144 Tftp Configuration File EntriesTags in the bootptab file 2 TCP/IP Configuration Ews-config Tftp Configuration File Parameters 1Tftp Configuration File Parameters 2 Tftp Configuration File Parameters 3 Using DhcpWindows Systems Unix SystemsWindows 2000 Server/Server TCP/IP Configuration Enabling or Disabling Dhcp Using Rarp Using the arp and ping Commands Unix Using Telnet TCP/IP Configuration Telnet Configuration Parameter Examples 192.168.10.1 Telnet Configuration Parameter Examples 1Banner0 Telnet Configuration Parameter Examples 2Using Telnet to Erase the Existing IP Address Using the Embedded Web ServerMoving to Another Network About LPD Configuring for LPD Printing IntroductionLPD Programs and Protocols Program Name Purpose of Program Requirements for Configuring LPDSupported Queue Names LPD Setup OverviewSetting Up IP Parameters Setting Up Print QueuesPrinting a Test File Example Configuring Print Queues for BSD-based SystemsLPD on Unix Systems Example Configuring Print Queues Using SAM HP-UX systems For HP-UX systems, substitute lp -dfor lpr -P LPD on Windows 2000/Server 2003 Systems Installing TCP/IP SoftwareConfiguring for LPD Printing Add LPR compatible printer window Select and enable Other Network File and Print ServicesPrinting from Windows Clients Verifying the ConfigurationRequirements FTP Printing IntroductionControl Connection Using FTP PrintingPrint Files FTP ConnectionsEnding the FTP Session FTP LoginCtrl-C CommandsUser Commands for HP Jetdirect FTP Server Description This is an example of a typical FTP printing session Example of an FTP SessionTroubleshooting the HP Jetdirect Print Server Introduction HP Jetdirect External Print Servers Resetting to Factory DefaultsTroubleshooting Chart Assessing the Problem General TroubleshootingProcedure 2 Printing an HP Jetdirect Configuration Procedure 1 Verifying that the Printer is On and OnlineProcedure 3 Resolving Printer Display Error Messages Telnet IP address port Frames are using the same network Ethernet Configuration External Single Port Print Servers Troubleshooting the HP Jetdirect Print Server Ethernet configuration pages HP Jetdirect Configuration Page Messages IntroductionHP Jetdirect Product Information General HP Jetdirect Messages 1 General HP Jetdirect Messages 2 General HP Jetdirect Messages 3 General HP Jetdirect Messages 4 General HP Jetdirect Messages 5 General HP Jetdirect Messages 6 General HP Jetdirect Messages 7 General HP Jetdirect Messages 8 General HP Jetdirect Messages 9 General HP Jetdirect Messages 10 Network Statistics Source Routing Novell NetWare Configuration Messages 1IPX/SPX Status ModeDLC/LLC Configuration Messages Novell NetWare Configuration Messages 2TCP/IP Configuration Messages 1 Apple EtherTalk Configuration Messages 1 TCP/IP Configuration Messages 2Name Apple EtherTalk Configuration Messages 2Snmp Messages Snmp SET CmtyTransmission Control Protocol TCP TCP/IP Overview IntroductionInternet Protocol IP IP Address Network Portion IP AddressUser Datagram Protocol UDP IP Address Structure and Class IP Address Host Portion88 TCP/IP Overview Dynamic Host Configuration Protocol Dhcp Configuring IP AddressesSubnet Mask SubnetsGateways Default GatewayFigure B.1 Embedded Web Server Using the Embedded Web Server IntroductionBrowser Exceptions Supported HP Web Jetadmin VersionCompatible Web Browsers Figure B.2 Entering the IP Address Viewing the Embedded Web ServerOperating Notes Special FeaturesIndex Configuration ErrorIndex Network Frame Type Rcvd OUT of Buffers Overflow Error Tftp Progress Local Error Remote Error 76 Retries Exceeded Page Enww