0x0E control data address mark detected (hard disk) 0x0F DMA arbitration level out of range (hard disk) 0x10 uncorrectable CRC or ECC error on read 0x11 data ECC corrected (hard disk)
0x20 controller failure
0x31 no such drive (Compaq)
0x32 incorrect drive type stored in CMOS (Compaq)
0x40 seek failed
0x80 timeout (not ready)
0xAA drive not ready (hard disk) 0xBB undefined error (hard disk) 0xCC write fault (hard disk)
0xE0 status register error (hard disk) 0xFF sense operation failed (hard disk)
Battery
Battery type = None (OK), LiIo (OK), NiMH (OK), ERROR (BIOS not sure) Charge state = NA (no bat), NC (no charger), FC (fast charge),
TC (trickle charge), EC (error charging), WC (waiting to charge) B%=100 (percent of battery charged)
Vb=8.57 (battery voltage) Ta=37.9 (Ambient temperature)
SCSI loopback test
Failure: "X" Register Read/Write Error
Failure: NO CABLE, Couldn't find SCSI controller #N
Failure: "X" Pin #N ("X") is stuck low.
Failure: "X" Pin #N ("X") is stuck high.
Failure: "X" Interrupt line problem
Failure: "X" can't Bus Master
Failure: "X" can't issue interrupt
HP mouse
Unable to prepare internal mouse for i/o. Failed: "X" bumper ON while moving "X".
Failed: "X" bumper and movement "X" at the same time.
Failed: (one or more of LEFT RIGHT UP DOWN TOP BOTTOM IN OUT)
Failed: HMICKEYS or VMICKEYS
Failed: Vertical calibration lost
Failed: Horizontal calibration lost
Docked device
Ok: NOTHING
Ok: 800 DOCK
Failed: Red LED
Failed: Green LED
Failed: Dock Lock
Ok: SCSI CABLE
Error: UNCLEAR
Dock PS2 mouse
Failed: no dock connected for PS2 mouse.
Failure code N ("X" while enabling external PS2 mouse.
Failed: (one or more of LEFT RIGHT UP DOWN)
89