HP Book 800CT manual Cpu, Connector

CPU

(HP Authorized Service Providers Only)

Required Equipment

∙Torx #6 screwdriver

Removal Procedure

1.Follow the Display Removal Procedure to gain access to the CPU.

2.Remove the two CPU screws (see Figure 37).

3.Gently rock the CPU back and forth from front to back to remove from the connector.

CPU Screws M1.6x0.35x4.0mm 1.0-2.0 in-lb

(p/n 0515-2852)

CPU

CPU Insulator

(p/n F1360-20007)

Figure 37 - Removing the CPU

Replacement Procedure

1.Ensure the CPU Insulator is positioned over the CPU connector on the Logic PCA.

2.Position the replacement CPU over the connector on the Logic PCA and press firmly but gently. For F1360 units, please refer to the Heat Transfer Disk information on page 68.

CAUTION:	To avoid damage, apply pressure to the CPU only directly above the
	connector.

3. Replace the remainder of the components and reboot.

67