HP Book 800CT Keyboard Failure, Machine is Locked Turn KEY, No Bootable Floppy Drive 0 Installed

Page 24

Message

Possible Cause

KEYBOARD FAILURE

The keyboard failed to respond to the

 

RESET ID Command.

MACHINE IS LOCKED - TURN KEY

The system will not continue the boot

 

sequence until you insert the key into the

 

key lock and turn it.

NO BOOTABLE FLOPPY DRIVE 0 INSTALLED

No bootable floppy drive was detected.

 

Possible solutions: 1) Power down the

 

system and check all appropriate

 

connections, cables, etc. 2) In

 

configurations where no floppy drive is

 

installed, run System Configuration Utility

 

and make sure the diskette drive

 

configuration item is set to “None”. 3)

 

Replace the diskette drive if necessary.

NO INTERRUPTS FROM TIMER 0

The periodic timer interrupt is not

 

occurring.

RAM PARITY ERROR AT LOCATION xxxx

A RAM parity error occurred at the

 

specified (hexadecimal) location.

ROM AT xxxx (LENGTH YYYY) WITH NON-ZERO

An illegal adapter ROM was located at

CHECKSUM (zz)

the specified address. An external

 

adapter (such as a video card) may be

 

causing a conflict.

TIME/DATE CORRUPT - RUN SCU

The time and date stored in the real time

 

clock have been corrupted, possibly by a

 

power loss.

UNEXPECTED AMOUNT OF MEMORY - RUN SCU

The amount of memory detected by

 

POST does not match the amount

 

specified in CMOS RAM.

CMOS RAM TEST FAILED

A walking built test of CMOS RAM

 

locations 0E (Hex) - 3F (Hex) failed.

DMA CONTROLLER FAULTY

A sequential read/write of the transfer

 

count and transfer address registers

 

within the primary and secondary DMA

 

controllers failed.

FAULTY DMA PAGE REGISTERS

A walking bit read/write of the 16 DMA

 

controller page registers starting at

 

location 80 Hex failed.

FAULTY REFRESH CIRCUIT

A continuous read/write test of port 61h

 

found that bit 4 (Refresh Detect) failed to

 

toggle within an allotted amount of time.

INTERRUPT CONTROLLER FAILED

A sequential read/write of various

 

Interrupt Controller registers failed.

ROM CHECKSUM INCORRECT

A checksum of the ROM BIOS does not

 

match the byte value at F000:FFFF.

6

Image 24
Contents HP OmniBook 800CS/CT Page Table of Contents Hard Disk Drive Floppy Disk Drive CD-ROM Drive OmniBook 800 External Features List of FiguresDiagnostic Commands for Toggling Settings List of TablesIntroduction Resource Number/Address CommentsPage Part Product Overview Feature OmniBook 800 with MMX F1360 F1171 F1175 What’s New1MB RAM Product Features OmniBook 800 External FeaturesExploded Diagram Product at a GlanceParts Identification Number Part Number ReplaceableProduct Comparisons HP OmniBook With MMX Technology2MB 1MB ∙ RAM IDEDram Pcmcia ∙ PC IDBattery and accessories On battery Accessories Page Page Page Part Troubleshooting Power-On Self-Test Beep CodesPost Beep Codes Display Codes Post Display CodesMessage Possible Cause No Bootable Floppy Drive 0 Installed No Interrupts from TimerDMA Controller Faulty Faulty DMA page RegistersOmniBook Diagnostics Running the diagnostics programMain diagnostic screen Main Diagnostic Screen Running selected tests Special test hardware requirements Alternative methods for running testsLoop Back Connectors Serial Loop Back ConnectorPcmcia Type III extender card SyCard Solder BridgesCommand line options Diagnotic Command Line OptionsSwitch Description User interface commands Commands for test selectionDiagnostic Test Selection Commands Command DescriptionCommands for toggling test settings Diagnostic Commands for Toggling SettingsMouse switch Key Action Diagnostic Hidden Commands Commands for setting test parameters Diagnostic Test ParametersDetails on using the diagnostic tests CacheRAM, motherboard RAM, plug Upper PC CardTimers Lower PC CardReal time clock IRQ controllerBattery Serial portPrinter port Hard diskText mode mouse test KeyboardOUT TOPBOT LeftMouse Test Screen text mode Graphic mode mouse sine test Mouse Test Screen graphics mode Text mouse and graphic sine mouse tests selected Graphic draw screen mouse test selectedAudio DisplayDocked device Scsi Hard diskDock keyboard Dock EepromContents of the DMI Package Desktop Management Interface DMIDescription of DMI LAN CD-ROMMIF Installing the DMI Package from Windows Uninstalling the DMI Package from WindowsUsing the DMI Interface Setup and Configuration SCU Main ScreenSystem Menu Settings Boot Devices…System Menu Screen Date and Time…Passwords… Enable CacheStatus Panel Enable Status Panel Settings…Password Configuration System Password MatrixPC ID Input/Output Menu Screen Enabled IrDA IR External Devices…Audio Port… Video StretchedPower Menu Screen Port ActivityIRQ3, IRQ4, IRQ5 IRQ7, IRQ9Default Menu Screen Default Menu SettingsFactory Default SettingsExit Menu Screen Troubleshooting Tips OmniBook Troubleshooting TipsSymptom Call Center Repair Center OmniBook ComponentsPower/battery Computer won’t turn On/won’t bootLockup/computer freezes Computer noisy but working MiscellaneousSymptom Call Center Repair Center CD ROM Drive Troubleshooting BiosCD-ROM Troubleshooting Tips Trouble Possible Causes SolutionsResolving Docking Station Operating Problems If an external PS/2 mouse or keyboard doesn’t workResolving OmniBook Docking Problems If a network-enabled system locks up when rebootingIf your docking password isn’t accepted If network connections don’t workPage Part Hardware Repair Battery Removal ProcedureRequired Equipment Memory 16-MB Memory ModulesRemoving the Memory Module Replacement Procedure Hard Disk Drive Hard Drive ScrewsFolding the Keyboard Open DischargeHard Drive Removal Replacement Procedure Inserting the Hard Drive Hard Disk Drive Breather Holes IBM and Toshiba Hard Drive Breather Holes respectivelyRemoving the Mouse Replacement Procedure MouseBattery Latch Small PartsKeyboard Keyboard ScrewsSecurely into the zero insertion force connectors Under the keyboardDisplay Bottom Case Screws and Rubber FeetF1360 only F1171 F1175 Keyboard Support Plate ScrewsDisplay Flex Cables Top Case and Display Removal Intel Inside Sticker Placement Connector CPUHeat Transfer Disk Heat Transfer Disk and Keyboard Support InsulatorPage Logic PCA Board Electronic Serial NumberProgramming the Electronic Serial Number Overriding an Incorrect Electronic Serial NumberLogic PCA Removal Grommet and Bushing Placement Paw Active Paw Active RemovalOther Components and Accessories Page Page Appendices Appendix a Technical Specifications Mass Storage SpecificationsHard Disk Drive Floppy Disk DriveFloppy Disk Drive Specifications CD-ROM Drive SpecificationsCD-ROM Drive Inch Floppy DriveSystem Resources System Interrupts IRQsInterrupts for F1171 F1175 Interrupts for F1360DMA Channels Memory MapDMA Channels for F1171 F1175, and F1360 Memory Map for F1171 F1175Addresses O Address for F1171 F1175Ffff O Addresses for F1360Appendix B Hewlett-Packard Password Removal Policy Page Appendix C Hewlett-Packard TFT Display Quality Statement Appendix D OmniBook Diagnostics Bios Checksums OmniBook F1171 F1175 Bios ChecksumsAltera Boot Total SUM OmniBook F1360 Bios ChecksumsAppendix E OmniBook Diagnostics Error Messages Bios flash romsHewlett-Packard supplied test messages Fail C-F=XXXX#YYYYDisk Drives Scsi HD / internal HD / Floppy Scsi loopback test Watergate Software supplied test messages CPU test responsesCo-CPU test responses Memory test responses Cache test responsesVGA test responses Timer chip test responses Cmos RAM test responsesSound test responses Keyboard test responsesCOM test responses IRQ test resonsesDMA test responses HD test responsesCD ROM test responses Appendix F Part Numbers F1171 F1360F1175 External Battery LI-ION BatteryCD-ROM Power Cable SVC Kybrd TopcaseOB Lightweight Setup Guide EnglishSetup Guide E,G,F,S,I Setup Guide E,D,S,F,NFrench ItalianGerman SpanishPage HP Part Number F1360-90049