Fill the Fluid Supply
1.Discharge the system voltage (page 20).
2.Relieve the pressure (page 20).
ti1276a
3.Open the isolated enclosure door.
4.Remove the pail cover from the pail, holding a rag over the suction tube strainer to prevent any fluid from dripping into the isolated enclosure. Place the cover and suction tube outside the enclosure.
5.Remove the supply pail from the enclosure.
Operation
WARNING
Fire and Explosion Hazard
To reduce the risk of fire and explosion, only use this equipment with fluids that meet at least one of the following conditions for
•The fluid has a flash point above 140°F (60°C) and a maximum organic solvent concentration of 20%, by weight, per ASTM Standard D93.
•The fluid does not sustain burning when tested per ASTM Standard D4206 Sustained Burn Test.
CAUTION
Be sure to wipe up all fluid spills in the isolated enclo- sure. Fluid can create a conductive path and cause the system to short out.
6.Clean up any fluid spills in the enclosure, using a soft cloth and a
7.Fill the supply pail with fluid and return it to the enclosure. Clean up any spills.
8.Reinstall the pail cover, holding a rag over the suc- tion tube strainer to prevent fluid spills while you place the pump suction tube in the pail.
9.Close the isolated enclosure door and fasten securely with the
Adjust the Spray Pattern
Follow the steps below to establish the correct fluid flow and air flow.
WARNING
Electric Shock Hazard
Contact with the charged components of the spray gun will cause an electric shock. Do not touch the gun nozzle or electrode or
come within 4 in. (102 mm) of the front of the gun during operation or until performing the Fluid Voltage Discharge and Grounding Procedure on page 20.
Follow the Fluid Voltage Discharge and Grounding Procedure on page 20 when you stop spraying and whenever you are instructed to discharge the voltage.
WARNING
Component Rupture Hazard
To reduce the risk of component rupture, which can cause serious injury, do not
exceed the maximum working pressure of the lowest rated system component. This equipment has a 100 psi (0.7 MPa, 7 bar) maximum working air and fluid pressure.
309293J | 21 |