HP 700 G1 manual Using Computer Setup F10 Utilities

Page 64

Using Computer Setup (F10) Utilities

Computer Setup can be accessed only by turning the computer on or restarting the system. To access the Computer Setup Utilities menu, complete the following steps:

1.Turn on or restart the computer.

2.Repeatedly press F10 when the monitor light turns green to access the utility.

You can also press Esc to a menu that allows you to access different options available at startup, including the Computer Setup utility.

NOTE: If you do not press F10 at the appropriate time, you must restart the computer and again repeatedly press F10 when the monitor light turns green to access the utility.

NOTE: If the Computer Setup (F10) Utility is set to “fast boot”, use one of the following procedures to access Computer Setup:

●Before turning on the computer, press and hold F10. Turn on the computer and continue to hold F10 until the Computer Setup (F10) Utility is displayed.

- or –

●Follow the Windows 8.1 instructions for rebooting the computer into the Computer Setup (F10) Utility.

3.A choice of five headings appears in the Computer Setup Utilities menu: File, Storage, Security, Power, and Advanced.

4.Use the arrow (left and right) keys to select the appropriate heading. Use the arrow (up and down) keys to select the option you want, then press Enter. To return to the Computer Setup Utilities menu, press Esc.

5.To apply and save changes, select File > Save Changes and Exit.

●If you have made changes that you do not want applied, select Ignore Changes and Exit.

●To reset to factory settings or previously saved default settings (some models), select Apply Defaults and Exit. This option will restore the original factory system defaults.

NOTE: Not all settings shown in the following sections are available for all models

CAUTION: Do NOT turn the computer power OFF while the BIOS is saving the Computer Setup (F10) changes because the CMOS could become corrupted. It is safe to turn off the computer only after exiting the F10 Setup screen.

56 Chapter 5 Computer Setup (F10) Utility

Image 64

Contents Maintenance and Service Guide Product notice Safety warning notice IiiIv Safety warning notice Table of contents Sata data cable System board callouts103 106107 108122 123126 ViiiProduct features Standard configuration featuresProduct features Front panel componentsRear panel components Rear panel componentsSerial number location Microtower MT chassis spare parts Illustrated parts catalogComputer major components Illustrated parts catalog Cables Item Description Front I/O assembly Sata drive power cableSata data cable, 14 inch, 1 straight end, 1 angled end Misc parts USB Wireless Washable Smart card Antenna for use with Wlan cardDescription Hard drives/Solid-state drives DrivesOptical drives Microtower MT chassis spare parts Misc boardsItem Description Generating static Electrostatic discharge informationRelative Humidity Event 55% 40% 10% Preventing electrostatic damage to equipment Personal grounding methods and equipmentGrounding the work area Static Shielding Protection LevelsOperating guidelines Recommended materials and equipmentGeneral cleaning safety precautions Cleaning the Computer CaseCleaning the keyboard Routine careService considerations Cleaning the monitorCleaning the mouse Power supply fanCables and connectors Lithium coin cell batteryScrews Hard DrivesSerial ATA Hard Drive Characteristics Sata hard drivesSata hard drive cables Smart ATA drivesCable management Removal and replacement procedures Microtower MT chassis Preparation for disassemblyAccess panel Front bezel Optical drive bezel blank Memory DIMMsDDR3-SDRAM DIMMs Populating Dimm socketsInstalling DIMMs Page Expansion cards Removal and replacement procedures Microtower MT chassis Page Drives GB Solid-state Drive SSD Drive positions Removing a slim optical driveInstalling a slim optical drive Removing a hard drive Installing a hard drive Page Page Page Battery TypeType Drive power cable Front I/O and power switch assembly Page Removal and replacement procedures Microtower MT chassis Heat sink Processor Speaker Rear chassis fan Power supply Page System board Page System board callouts Sys Bd Label Color ComponentWhite Pin main power connector Blue Front I/O/power switchBlack Media card reader connector Black PCI Express USB3.0Computer Setup F10 Utility Computer Setup F10 UtilitiesUsing Computer Setup F10 Utilities Computer Setup-File Computer Setup-Storage Computer Setup F10 UtilityComputer Setup-Security Network Boot Master Boot SecurityDevice Security USB SecuritySecure Boot ConfigurationLegacy Support to disabled System Security theseComputer Setup-Power Hardware PowerOption Description ManagementComputer Setup-Advanced Power-On OptionsBios Power-On OptionVGA Configuration Connected BiosBus Options Device OptionsRecovering the Configuration Settings Troubleshooting without diagnostics Safety and comfort Before you call for technical supportHelpful hints Solving general problems Computer will not respond to keyboard or mouse CauseSolving general problems Apps icon Poor performance Cause SolutionUnder Windows System, click Run Processor thermal protection activated Solving power problems Power supply shuts down intermittently Cause SolutionSolving hard drive problems Solving hard drive problemsNonsystem disk/NTLDR missing message Cause Solution Storage Boot Order listComputer will not boot from hard drive Cause Solution Storage Boot OrderSolving media card reader problems Solving media card reader problemsCan not write to the media card Cause Solving display problems Inserted media card has boot capabilityBlank screen no video Cause Solution To the electrical outletSolving display problems Blank screen no video CauseDim characters Cause Solution Install the video drivers included in the upgrade kitBe sure the monitor cable is securely connected to Monitor needs to be degaussedImage is not centered Cause Solution Position may need adjustmentNo Connection, Check Signal Cable displays on screen Cause Horizontal or vertical position of the imageCertain typed symbols do not appear correct Cause Solving audio problemsSound cuts in and out Cause Solution Solving audio problems Solving printer problems Printer will not print Cause SolutionLine-in jack is not functioning properly Cause Control Panel , and then select Device ManagerSolving keyboard and mouse problems Solving keyboard and mouse problemsPrinter prints garbled information Cause Solution Make the proper network connections to the printerKeyboard connector is not properly connected Program in use has stopped responding to commandsShut down the computer using the keyboard Computer, and then restart the computerSolving Hardware Installation Problems Solving Hardware Installation ProblemsThat pins in the connector are not bent down Mouse may need repairComputer will not start Cause Solution Solving Network Problems Solving Network ProblemsNetwork status link light never flashes Cause Solution Correct operating mode Diagnostics reports a failure Cause SolutionSettings for the board Cable CorrectlySolving memory problems New network card will not boot Cause SolutionSolving memory problems Out of memory error CauseMemory count during Post is wrong Cause Solution Insufficient memory error during operation Cause SolutionComputer Setup utility Solving CD-ROM and DVD problemsSecurity Network Boot Movie will not play in the DVD drive Cause Solution Solving CD-ROM and DVD problemsCannot eject compact disc tray-load unit Cause Solving USB flash drive problems USB flash drive not found identified Cause SolutionSystem will not boot from USB flash drive Cause Solution Security USB SecuritySolving Internet access problems Solving front panel component problemsSolving front panel component problems Solving software problems Delete buttonLog on to your ISP and launch the desired program System files may be damagedAdvanced startup, click Restart now Solving software problemsSelect Automatic Repair Post error messages Post error messagesPost numeric codes and text messages Control panel message Description Recommended actionDownload to Disable to prevent PXE Post numeric codes and text messagesFlash Screen Image Corrupted Flash Screen image has errors ECC Memory Module Detected ECCEnsure that none of the keys are DepressedPower Supply fan not detected Reseat power supply fanReconfigure card resources and/or run Computer Setup or Windows utilitiesSata Cabling Error One or more Sata devices are improperly Reboot the computerFunctionality contained in the system Bios System Bios versionActivity Beeps Possible cause Recommended action Causing the failure. Continue adding devices Pre-video graphics error For systems with a graphics cardRed Power LED flashes seven Times, once every second Unable to bootPress and hold the power button for less than Check that both power supply cables areReplace the power button harness. If Problem persists, replace the system boardPassword security and resetting Cmos Resetting the password jumperChanging a Setup or Power-On password Clearing and resetting the Cmos Deleting a Setup or Power-On passwordPress Enter Page Why run HP PC Hardware Diagnostics HP PC Hardware DiagnosticsHow to access and run HP PC Hardware Diagnostics Diagnostic section, click HP Uefi Support Environment Creating recovery media and backups System backup and recoveryRestoring and recovering using Windows tools Using Reset when the system is not responding Select Reset Follow the on-screen instructions to continueBacking up, restoring, and recovering in Windows Creating recovery media Click All ProgramsTo create recovery discs Close all open programs To create the Windows DVD System backup and recoverySystem Restore Follow the on-screen instructions to set up your backupSystem Recovery System Recovery when Windows is respondingSystem Recovery when Windows is not responding Select Install now Page Japanese Power Cord Requirements Power Cord Set RequirementsGeneral Requirements Country-Specific Requirements Country-Specific RequirementsCountry Accrediting Agency Statement of Volatility Appendix B Statement of VolatilityEnter the F10 setup utility MT Specifications SpecificationsAppendix C Specifications Plus Platinum MT SpecificationsRated Input Current Current Leakage Nfpa Index 116 Installing Expansion card Hard drive Computer SetupMT heat sink MT power supply Helpful hints Hood sensor IllustratedMT bezel blank MT front bezel Optical drive Resetting 112 Safety and comfort Safety precautions CleaningSystem restore points, creating MT speaker

Related manuals

Manual 12 pages 58.88 Kb

Manual 46 pages 7.81 Kb