York DR120, DR090 manual Features, PREDATOR MagnaDRY DR150, YTG-C-0606

246721-YTG-C-0606

	Simplicity™ Control	Disconnect	Filter access
	board w/screw
Second model		location (optional	(2" throw-away)
	connectors for T-stat
		disconnect switch)
nameplate inside			Filter drier (solid core)
	wiring and Network
hinged access panel
	Connection
			Condenser Section
Dual stage cooling			Belt-drive blower
for maximum
			motor
comfort
			Slide out motor
Compressor #2			and blower
			assembly for easy
access
			adjustment and
(high-efficiency
			service
compressor w/
crankcase heater)			Power ventor
			motor

Base rails w/ forklift slots

(three sides)

and lifting holes

Roof curbs in eight-and fourteen-inch heights.

Roof curbs for

transitioning from York Sunline TM footprint to the DM/DH/DJ Series footprint are available (field-installed accessory)

Tool-less door

latch

Side entry power and control wiring knockouts

Slide-out drain pan with brass ¾" NPT, female connection

Compressor #1 access

(high-efficiency

compressor w/crankcase

heater)

20-gauge

aluminized steel

tubular heat

exchanger for

long life

(stainless steel

option)

Two-stage gas heating to

maintain warm,

comfortable temperature

Intelligent control board for safe and efficient operation

FIGURE 2 - PREDATOR® MagnaDRY™ DR150

FEATURES

•High Efficiency – High efficiency units reach as high as 11.2 EER. Gas/electric units have electronic spark igni- tion and power vented combustion with steady state effi- ciencies of 80%. These efficiencies exceed all legislated minimum levels and provide low operating costs.

•Service Friendly – The Predator® incorporates a num- ber of enhancements which improve serviceability.

The motor and blower slide out of the unit as a common assembly. This facilitates greater access to all the indoor airflow components, thus simplifying maintenance and adjustment.

Service time is reduced through the use of hinged, tool- less panels. Such panels provide access to frequently inspected components and areas, including the control box, compressors, filters, indoor motor & blower, and the heating section. The panels are screwed in place at the factory to prevent access by children or other unautho- rized persons. It is recommended that the panels be secured with screws once service is complete.

Service windows have been placed in both condenser section walls. Rotation of the cover allows easy access to the condenser coils for cleaning or inspection.

Both the unit control board and ignition control board utilize flash codes to aid in diagnosis of unit malfunctions. Unique alarm codes quickly identify the source of the unit alarm.

All units use the same standard filter size. This standard- ization removes any confusion on which filter sizes are needed for replacement.

The non-corrosive drain pan slides out of the unit to per- mit easy cleaning. The drain pan is accessed by remov- ing the drain pan cover plate on the rear of the unit. Once the plate is removed, the drain pan slides out through the rear of the unit.

All Predator® units have a second model nameplate located inside the control access door. This is to prevent deterioration of the nameplate through weathering.

•Environmentally Aware – For improved Indoor Air Quality, foil faced insulation is used exclusively throughout the units.

•Balanced Heating – The Predator® offers “Ultimate Heat- ing Comfort” with a balance between 1st and 2nd stage gas heating. The first stage of a gas heat Predator® unit provides 60% of the heating capacity. Balanced heating allows the unit to better maintain desired temperatures.

•Convertible Airflow Design – The side duct openings are covered when they leave the factory. If a side supply/

Unitary Products Group 5